Recent content by Robert Irwin

  1. R

    IH 3 bottom fast hitch plow identification

    Hello all, Can you all identify if this is a model 311 plow? I can’t find a badge on it anywhere. I don’t have the fast hitch arms bolted to it yet. Also, if anyone has an idea on where to find new coulters for it? Much appreciated. Robert
  2. R

    IH 560 diesel parasitic draw issue

    Btw, I did get a second alternator and it also had the same draw. I’m just going to install a battery cut off switch to resolve the pull when the tractor is not in service.
  3. R

    IH 560 diesel parasitic draw issue

    Thank you for the info.
  4. R

    IH 560 diesel parasitic draw issue

    I wondered when I first posted if I was using the right forum. Thank you much
  5. R

    IH 560 diesel parasitic draw issue

    Thank you much for the feedback. Btw, I did get a battery disconnect switch. I think I’ll go ahead and install it.
  6. R

    IH 560 diesel parasitic draw issue

    For measuring the voltage, I have the ground cable disconnected from the battery, connected the positive battery cable to the positive battery terminal. Then connect multimeter negative to ground cable and use the positive multimeter tip to touch the negative battery terminal while having the...
  7. R

    IH 560 diesel parasitic draw issue

    Ok, well I’m still stumped. I went at it again tonight and have more info for you. I first disconnected the green wire at the junction block and still read 11.95v on the multimeter. Put it back on the block and pulled off the blue wire that runs to the alternator. Bang, multimeter went to 0...
  8. R

    IH 560 diesel parasitic draw issue

    Hi Used Red MN, unfortunately it didn’t work. I taped back the yellow wire at both ends, connected just blue to alternator and then connected grey, blue and green together at the junction block. Still showing 11.95v on the multimeter. Pictures attached. Any other ideas?
  9. R

    IH 560 diesel parasitic draw issue

    Thanks so much for the info. I’ll let you know how it goes.
  10. R

    IH 560 diesel parasitic draw issue

    Thank you Wore Out
  11. R

    IH 560 diesel parasitic draw issue

    Thank you much. I’ll give that a try tonight. Does the junction block I got need to be grounded if I use it as the screw holes are plastic? Can the old VR still be used to connect those three wires together? If so, would it matter what terminal to connect them?
  12. R

    IH 560 diesel parasitic draw issue

    Currently on L terminal. I originally had them split with a jumper wire between and have also tried them all on the gen terminal. I tried a plain junction block that I picked up off Amazon as well.
  13. R

    IH 560 diesel parasitic draw issue

    Thanks Rustred, Good news, I’ve got the one 12v and two 6 volt generators I can send to you. Btw, how would you suggest I junction those four wires together?
  14. R

    IH 560 diesel parasitic draw issue

    Btw, I also checked the fuse in the harness/dash and was good. The wiring harness is practically new and I checked continuity of the wires as well.
  15. R

    IH 560 diesel parasitic draw issue

    Good evening, I recently converted from 12v generator to 1 wire alternator on my IH 560. I was instructed to connect the field and Gen wires together on the “1 wire stud” on the alternator and then combine “field, Gen, batt & L” wires at the voltage regulator as it essentially acts as a...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top