(800) 853-2651
SHOP NOW

Recent content by robreynolds

Yesterday's Tractor Forums
  1. R

    deere 4219 rod bearing size

    So far I have 2.747 and 2.746.
  2. R

    deere 4219 rod bearing size

    Thanks for the tip. What vendor does that phone number belong to? The reason this backhoe needs an overhaul is because it had water in the cylinders for a few years, which ruined the compression. How the water got in was a mystery at first because it has a rain cap on the pipe. But then I...
  3. R

    deere 4219 rod bearing size

    Thanks. That's pretty much what I needed to know to get started.
  4. R

    deere 4219 rod bearing size

    Thanks. Mine are marked T-20011. It didn't seem to relate to the size.
  5. R

    deere 4219 rod bearing size

    Gee, I looked at my micrometer, but I can't find where it displays the factory spec for my rod journals. All it shows is the actual size of the ones in my backhoe.
  6. R

    deere 4219 rod bearing size

    Gee, I looked at my micrometer, but I can't find where it displays the factory spec for my rod journals. All it shows is the actual size of the ones in my backhoe.
  7. R

    deere 4219 rod bearing size

    I"m doing an in-frame rebuild on a Deere 410 backhoe, 4219 diesel engine. I pulled the pan and a rod bearing cap to see which bearings to order with my kit, but I don"t know what the nominal value is supposed to be, so I can"t tell whether I need standard or oversize. I suppose I would get...
  8. R

    starting diesel engine that had water in it

    I checked the lines where they attach to the injectors, and there was fuel there. I noticed a bit of smoke, although not a lot. Maybe it will get more smoke as I continue cranking the engine.
  9. R

    starting diesel engine that had water in it

    I just checked again, and there was very good suction on the intake manifold, with just one cylinder being weaker than the other three. I poured a bit of oil in it and a sprayed a lot of ether, and still no fire.
  10. R

    starting diesel engine that had water in it

    That's a pretty good idea. I put my hand over the air intake and felt one really good suction, but the other three were somewhat less. I thought it felt halfway decent overall. It would be smart to check the valves, though.
  11. R

    starting diesel engine that had water in it

    My sister had a John Deere 410 backhoe sitting in a field for 4 years. It had water in the engine even though there was a rain cap on the pipe, so I had it hauled home without starting it. I drained about a gallon of crystal clear water out of the crankcase along with the oil. I left the...
  12. R

    trying to start old MF35

    You're probably right. It probably does run. Come to think of it, it would probably run (poorly) even if I had the wires going clockwise, because 2 of them would be correct, and it would probably at least fire even if there were up to 3 stuck valves or if the distributor were rotated...
  13. R

    trying to start old MF35

    I read somewhere that people used to enjoy reading but the internet is turning us into skimmers who read only the first sentence or two, glance at the middle, and then read the last sentence or two. I'm starting to believe it. Valves: check Compression: check Fuel: check...
  14. R

    trying to start old MF35

    Is the D 21 a hotter plug?
  15. R

    trying to start old MF35

    To be clear regarding the battery polarity, I don't know if this starter has field coils or permanent magnets. If the latter, reversed polarity would make the starter spin backwards. Upon further reflection, it would also cause the gear not to engage the flywheel, so that's a moot point. So I...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top