Recent content by Robster

  1. N

    Ferguson TO35 rear main bearing

    Which way do the rear main bearings go in on a Z134 engine. 1 bearing has an extra set of holes, does it go in the block or in the main cap. The IT manual says nothing about this. When I tore it apart it had no oil pressure & the bearing with the holes was in the cap. But it also had all new...
  2. R

    Ford 545C question

    Thanks Rod. The gentleman I am looking to purchase it from is letting me try it out this weekend, so I should be able to tell how it will perform. With construction down, good deals are to be had on equipment like this. (3K hours on it, clean too for only 5K). Farmers in my area (Central CA)...
  3. R

    Ford 545C

    Thanks for replying Rick. I realize HP is on the short side, but I only need to knock down the weeds on occassion, and I can raise the disc if it digs in too deep. With construction down, deals are to be had on this type of used equipment. Farmers in my area are holding on to their good...
  4. R

    Ford 545C question

    Agreed Ron. In order to disc properly and in a timely manner, you need the proper HP to do it, and I am sure it would take somewhere around 75hp to accomplish that with the disc I have. I only need to knock down the weeds on occassion, and its quite a chore for my trusty old 850. Anything...
  5. R

    Ford 545C question

    Thank you for the reply Rod. I've never weighed the disc, but I would guess it is probably in the lower weight range that you quoted. I have a old ford 850 (only tractor I've got at the moment) - and I can pull it in first gear to a max depth of half way up the dics - albeit feathering the...
  6. R

    Ford 545C

    Hello, new to posting but have visited this site many times and find the info very usefull. I have an opportunity to purchase a solid Ford 545C 4x4 (with loader and hyd. scraper), and would like to also use it on occassion to pull a 10" offset allis chalmers disc a couple of times a year (about...
  7. R

    Ford 545C question

    I have the opportunity to purchase a nice ford 545c 4x4 (w/loader & scraper). The tractor has a shuttle shift transmission. Question, can I pull my 10' allis chalmers off-set disc with it on occasion without hurting the transmission? Need to occassionally disc around 8 acres of flat level...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top