(800) 853-2651
SHOP NOW

Recent content by Rod Maker

  1. R

    Oliver 1800A Waukesha Swap Options

    How about a white military engine
  2. R

    Oliver 550 Freewheel

    My 550 backhoe did that before. I thought all kind of bad was going on inside the transmission. It ended up being the key on the wheel hub was cracked/broke and only catching in forward direction. It acted just like a sprag clutch.
  3. R

    Removing Transmission drain plugs help

    I have done this several times and it always has worked for me. Clean hole well, and use a breaker bar. Get a hydraulic jack, unscrew the extension a couple of threads and after getting breaker bar in place pump the jack against the breaker bar. You can get pretty firm pressure, but no need...
  4. R

    Removing the Knuckle Steering arm

    A variation of this is to have two people striking on opposite sides in unison. Takes a little practice to get the rythem, but the taper will pop loose.
  5. R

    White 100 engine removal

    Hello all. I have pulled Oliver / HPD several times, but this is my first trunnion mount. The clutch will not release when pressing the pedel down. It was working fine and then now it wont stop. I have a service manual and for clutch R&R is says to consult engine chapter, and the...
  6. R

    Trailer lights

    Over 80" wide are supposed to have three red lights in the middle to indicate a wide truck/trailer in front of you. Your take your chances without them.
  7. R

    1955 radiator

    If the tanks are good, I would put a new core in it.
  8. R

    550 forklift clutch

    <image src="http://forums.yesterdaystractors.com/photos/mvphoto6948.jpg"/>
  9. R

    550 forklift clutch

    Hello We have a 550 forklift that we bought on auction. After carb kit, new Venturi, electronic ignition, cap, rotor, plugs and wires, she runs excellent. But with this new found power the clutch slips bad. Trans code looks like 599. Spec code looks like 45-0014. Is this clutch tbe same as in...
  10. R

    2-70 White head gasket problems

    Sleeves can crack or pit.
  11. R

    No last word

    Hello, in my day job I work solving problems like this. While I generally prefer texting, a phone call can transmit many more details than texting. And throw in a need for following a flow chart one question at a time answered maybe hours or days apart, I wouldn't do it either. Many, many...
  12. R

    upper 3 pt shaft question on 4-150

    If you really want to, I think you can change the chain from PTO opening. I have not done this, but when I put my last one, I had the top of for extensive transmission repairs. I checked to see if I could reach from the rear. I felt I could, and would definitely try. My plan was to put a rag...
  13. R

    White 100 Speedometer

    Hello, I do not get any speed readout on the display. Does this speed come from a pickup on the pinion shaft? I installed a radar on the radar plug and it does not display anything either. Also how would speed be calibrated?
  14. R

    White 2-105 Shifting Proplems

    I welded mine up once when it happened twice in a month. I used a caliper and made it 0.010 inches thicker than the non worn part. It has never done it again.
  15. R

    Roosamaster pump conversion

    We are needing a 1550 diesel head, is yours any good, are you willing to sell it? Andy Schweringfarm(at)gmail
See more
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top