(800) 853-2651
SHOP NOW

Recent content by RodTag

Yesterday's Tractor Forums
  1. R

    Fuel leaking from Carb

    Will try that before I pull the seat. Thanks!
  2. R

    Fuel leaking from Carb

    Thanks for the added info!
  3. R

    Fuel leaking from Carb

    Thanks for the direction. Will try as soon as there is daylight!
  4. R

    Fuel leaking from Carb

    my 48 8n is leaking fuel constantly when I turn the fuel valve on. I was mowing when it began to spit and sputter. I looked down at the carb and saw it leaking out of the joint connecting it to the air breather. I turned the valve off, and it stopped leaking. I went back an hour later to try...
  5. R

    8n low power with load

    well it seems the hog had low oil in the tank. added some and mowed for an hour without any problems. Thanks you guys for the great advise.
  6. R

    8n low power with load

    Sorry I am just getting back to the forum. For some reason the form did not email me when responses were posted. All these ideas are good. I will check them one by one this weekend. Thanks again guys for point me in directions.
  7. R

    8n low power with load

    Sorry I am just getting back to the forum. For some reason the form did not email me when responses were posted. All these ideas are good. I will check them one by one this weekend. Thanks again guys for point me in directions.
  8. R

    8n low power with load

    Need some expert advise. I have the following. 8n front mount w/pentronix The tractor starts right up, shows 40 lbs oil pressure, and sounds strong without a load. When I run the brush hog it looses power when cutting grass that is not very high. It ran fine on Sat but noticed the oil pressure...
  9. R

    8N Won't start continued

    I guess I let it set just enough, it started for me tonight. YeeHaw! :) It is running good but is smoking a little. Could be the ATF in the oil and the one low compression cylinder. Anyway, on to the other steps on the tips list. Have rear seals, brakes and overall fluid changeout. Thanks to...
  10. R

    8N Won't start continued

    Continued from http://www.ytmag.com/cgi-bin/viewit.cgi?bd=nboard&th=764524 Okay, cleaned the plugs and the following is the list of compression. 1 - 55lb 2 - 75lb 3 - 69lb 4 - 80lb Tried to turn it over and it chugged for 2 secs and died in a white cloud from the exhaust. Probably from the...
  11. R

    8N wont start cont.

    Okay, cleaned the plugs and the following is the list of compression. 1 - 55lb 2 - 75lb 3 - 69lb 4 - 80lb Tried to turn it over and it chugged for 2 secs and died in a white cloud from the exhaust. Probably from the ATF coating in the cylinders. Anyway, the battery is about dead so I will...
  12. R

    8N wont start cont.

    I am going out now to clean the plugs and test the compression with my new gauge since my old one is leaking air around the gauge. :)
  13. R

    8N wont start cont.

    I have a 48 front mount with 12v. I installed a pentronix. I have good spark at the plug and I good flow of gas from the bottom of the carb. I pulled the air hose and after pulling the choke see fuel come out by the choke/hose. The tractor chugs like it wants to start and sometimes very briefly...
  14. R

    8N wont start cont.

    I filled ATF in each cylinder per a suggestion from Dell in the forum. The only problem is when I cranked the engine without the plugs the ATF did not come out. It seems the ATF all went into the crankcase with the oil. So, now I think I need to get a compression tester and see where the rings...
  15. R

    48 8N won't start

    Thanks, Dell.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top