Recent content by Ron Haling

  1. R

    Manifold shield for Farmall A

    I am restoring a Farmall A and have obtained a weather shield I wish to put on. What colour should the shield be-Manifold silver or Farmall Red?
  2. R

    Dzus Fasteners for early Farmall A

    I have an early 1940 Farmall A which uses the Dzus fasteners on the bonnet and the Radiator nose cone. There are 2 sizes available - 1 and 1/8 inch and 1 and 7/8 inch. Can anyone tell me where each of these are used. The couple that are left on my A are 1 and 7/8 inch. Thanks
  3. R

    12 V Starter Motor

    I want to put a 12V Starter on my W4 which currently has a 6V starter. Will the 12V Starter used on the Farmall 140 be suitable. Is there any other IH 12V Starter that will replace my 6V on the W4 and look the same as my 6V starter Many Thanks
  4. R

    Fitting Lights to Case VA

    I have restored a Case VA Serial No. 5164160 which is a 1947 model This model takes the Headlights on a Stem rod which I have obtained from USA supplier Can somebody tell me where and how these should be fitted on this tractor PLUS where do you fit the rear light Thanks Ron
  5. R

    Tractor Rear Drive Pulley for Farmall A

    Thanks for your reply My mower is actually an International C43 but I suspect the pulley would be the same as the Woods? Regards Ron
  6. R

    Tractor Rear Drive Pulley for Farmall A

    I am after a rear drive pully to fit a Farmall A.This pulley fits the shaft that also takes a belt pulley.The pulley I need drives the belt that in turn drives the underbelly mower.Can anyone advise where I could get this pulley Thanks Ron
  7. R

    Changing to 12V system Farmall Super A

    Thanks for your reply I have a 12V Generator
  8. R

    Changing to 12V system Farmall Super A

    I recently had an auto electrician modify my 6V generator with a cutout to 12V A Regulator was fitted but it is not charging.I have activated the system by cross connecting the but still doesn't charge. Can anyone advise? The light switch has the low charge/high charge switch from the old 6V system
  9. R

    1945 W4 Serial No. 13394

    Can anybody tell me if my 1945 W4 (Serial No l3394) is a McCormick Deering or a McCormick Also, does anyone have ideas how to stop Gasoline leaking out of the fuel cap (breather hole) on the large fuel tank.I do not want to damage the paint Many Thanks Ron
  10. R

    Placement of Decals on W4

    Thank you Glennster for your help Now there are a few other questions that I would be greatful for your help as to where to place: 'Hitch only to drawbar' decal 'Be Careful' is this the brake decal you refer to as it refers to 'always lock brake pedals together...' 'Do not attempt to pull when...
  11. R

    Placement of Decals on W4

    I have restored a 1945 W4 Where do you place the gear shift decal Do you place it on the rear section of the large fuel tank? Thanks Ron
  12. R

    26 inch rims and centres for W4

    Can anyone advise me if the 26 inch rims and centres used on an I4 and O4 are the same as used on the W4 and Super W4 Many Thanks Ron
  13. R

    26 inch wheels for a W4

    I am wanting to replace my 24 inch cast wheels on my W4 in Australia with 26 inch wheels which I would like to buy(used wheels) from USA and get them shipped here Can anyone advise which wrecking yards may have a set.I have tried JP tractors and they do not have any at the moment Regards Ron
  14. R

    paint for W4

    I want to paint my W4 with 2 pack paint Can someone advise the correct colour and code numbers for the paint Is it the same as the paint used on the Farmall"s Thanks Ron
  15. R

    Magneto Parts for Case VA

    Case Magneto
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top