-
R
cultivators
Ken, I have a working 1957 farmall 130 with a full set of cultivators. I would be glad to mount them up and take photos for you if needed.- Ron Thomas
- Post #1
- Forum: Farmall, International & McCormick
-
R
Farmall a rear wheel weight bolts?
My 130 manual says the following: for 1st set of weights four 5/8 N.C. 3 and 1/2 inch bolts, nuts and lock washers for the left wheel and 4 5/8 N.C. 5and 3/4 inch bolts, nuts and lock washers for the right wheel. Hope this is helpful!- Ron Thomas
- Post #1
- Forum: Farmall, International & McCormick
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy