(800) 853-2651
SHOP NOW

Recent content by Row Crop

Yesterday's Tractor Forums
  1. R

    Question

    I know this forum is for antique tractors, but I have a modern tractor question. I have a 285 hp two wheel drive with front assist. How large a soil finisher can I pull?
  2. R

    Antique trip plow

    I found an old antique trip plow, but I don't know what make it is. The only stamping on it is HTP, on different parts. It has spoke wheels, and is a two bottom. Any ideas?
  3. R

    Old plow

    I picked up an old 2 bottom trip plow at an auction. I don't know the make. It has "HTP" stamped in different places on it. Any ideas?
  4. B

    Massey Ferguson 285

    Thoughts? I don't know a lot about Masseys... Other than they are kind of pretty looking... :) Have the oppertunity to buy a Massey Ferguson 285, BIG tractor! 70 horse I think? Sounds like it has had a hard life. Guy I will be getting it from picked it up cheap, and was going to fix it, but...
  5. 1

    Pics-Results From Lange Sale Cole Camp,MO

    Yesterday I and a friend attended the Lange sale near Cole Camp,MO..It a cloudy,damp,and chilly day but a nice crowd showed up..Heres the pictures and results.. 1-MM GVI- $400- not running 2-Twin City KTA $300 -free but not running 3-Twin City 21-32 $180-I should have bought this one...
  6. P

    504 fast hitch info

    Hello guys...all of my experience thus far has been 1955 and prior: C, H, M...but I just found a 504 gas that is mechanically solid as a rock; recent engine and TA rebuild but need rubber and cosmetics. It is a drawbar tractor with dual remotes, question is...if I want to add a fast hitch is...
  7. R

    660 PTO

    I'll try that.
  8. R

    660 PTO

    The PTO on my 660 runs all the time unless I hold back on the lever. Do I need more shims, or less?
  9. R

    Oliver Super 77 RC tractor cast wheel

    Where you at?
  10. R

    Oliver 60

    What part of what state is it in?
  11. R

    I need an engine for my 88

    I have a 880 engine, with clutch and bell housing, intake and exhaust manifolds,carb, dist, etc attached. I'm in Mid-Michigan. E-Mail open.
  12. R

    Huge plow

    I seen some more pictures on Facebook today of this huge plow that was being pulled by at least three large dozers. They were plowing six to seven feet deep. Why would you want to do that?
  13. R

    Adding liquid to the planter.

    My 1770 planter is set up for 2x2, and I use 18-20 gal of 10-34-0. CCS vacuum with variable population. Best planter I ever had.
  14. R

    Super 55 motor remove and install

    Put a jack under the transmission, remove the front end, and pull the engine.
  15. R

    A Merry Christmas to all YTers!!!!!!

    Right back at ya!
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top