(800) 853-2651
SHOP NOW

Recent content by rpllr

Yesterday's Tractor Forums
  1. R

    230 buda parts

    Phil heisey in Philadelphia sells cockshutt tractor parts and would have 230 parts
  2. R

    Jet star 3 clutch

    I have seen where the throw out bearing can lock up and eat the fingers off the pressure plate.
  3. R

    Jet star 3 Super

    If you grind the valves put rings in it or it will smoke. If you have the heads milled make sure they do them together with the adapter plate on the top of them.
  4. R

    rpllr question

    I will check this weekend and get back to you
  5. R

    U302 Battery Cover

    I probably have one, in Indiana
  6. R

    Big Mo 500 Rear Hub

    I have one one a jet 3 industrial that is probably the same. Where are you located
  7. R

    425 LP engine swap

    Find a set of 504 blocks and pistons and put on your engine, or a 504 out of a g1000 would fit. 900 should be 451 and g1000 was 504. Welters in Missouri or stamm in Kansas probably have some.
  8. R

    3 bolt GTA 403 manifold

    I know of a guy who might have one for sale
  9. R

    pz haybob parts

    Hesston 3700 should be the same, made by pz agco dealer might be able to help
  10. R

    Tunica Results

    How about a site for photos?
  11. R

    South Dakota

    I will be there the week before thanksgiving near Freeman. Been going for about 12 years now
  12. R

    Hesston 60-66 tractors

    They are pretty good tractors in general start well in cold weather,and easy on fuel. Most parts like seals etc. Are available through case new Holland. Like any other brand it depends on how they were used previously.
  13. R

    Low Hour Hesston Tractor

    We have two of their utility tractors and they are pretty darn tuff. Probably about 8000 hours on one with a loader and have not touched it except for minor wear out parts and fixed a few leaks. We have gotten all the parts we need through case new Holland, but you need to help them with a part...
  14. R

    U Moline ??

    800+ if you have a fat enough wallet
  15. R

    1948 Cockshutt 30 Engine Rebuild/Puller

    With a little work I think a 2300 Hercules could be put in one
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top