Recent content by RQuam

  1. R

    Removing 1943 2N Carburetor Linkages

    Interesting idea. Thank you.
  2. R

    Removing 1943 2N Carburetor Linkages

    Many thanks to both of you for the answer to my question. I feel better now. This post was edited by RQuam on 10/06/2022 at 08:04 pm.
  3. R

    Removing 1943 2N Carburetor Linkages

    I'm about ready to replace the exhaust manifold (exhaust leakage at #4) and I've read most of the postings about the job but no one has mentioned removing the throttle and governor linkages to the carburetor. I was going to take off the manifold and carburetor together, as one unit. Is that the...
  4. R

    2N Ran Last Spring But Not Now

    agree with what you say about a battery maintainer. This tractor is always hooked to one when not in use.
  5. R

    2N Ran Last Spring But Not Now

    IT RUNS AGAIN! After correcting my stupid mistakes, I got it running again. The original issue, I think, was from the distributor. I installed a new one along with new coil, plugs and wires. Still wouldn't start. Thought it was a carb issue because when I pulled #4 plug, it was dry. One of...
  6. R

    2N Ran Last Spring But Not Now

    Thanks, Steve, for the suggestions. I'll let you know in a day or two.
  7. R

    2N Ran Last Spring But Not Now

    Yes, the choke is fully closing.
  8. R

    2N Ran Last Spring But Not Now

    My 2N sat all winter so I started it before summer just to make sure it would still run. It did and I was happy. But now it won't start. Pulled #4 spark plug and there is spark but after trying to start it, the plug is not getting wet. I'm thinking I have a carburetor issue. Loosened the...
  9. R

    Loose Steering On 9N

    Thanks for the replies. Sounds like I need to do a rebuild. Richard
  10. R

    Loose Steering On 9N

    The steering wheel will turn either direction about 2 inches with no movement of the linkage to the front wheels. Does that necessitate a rebuild of the steering box or are there some adjustments that would take up the slack? Richard
  11. R

    9N Generator Not Charging

    Thanks, guys, for the replies. Bruce (VA) asked: “Are you using an analog or digital meter?” Used an analog and the voltage stayed at 6 volts, no matter engine speed. And my apologies, Bruce, for asking without first looking at your tips. I had forgotten about them but did review them...
  12. R

    9N Generator Not Charging

    Voltage at the battery doesn't increase when the engine is running and there is no voltage at the generator output stud. I'm wondering if the generator needs polarizing after having the battery disconnected several times. If so, how do I polarize it? If not, what else can I check to see if...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top