(800) 853-2651
SHOP NOW

Recent content by ruger1

Yesterday's Tractor Forums
  1. R

    Ford 1710 wont move

    I have a ford 1710 that wont move at all after using it today for 10 minutes. Tractor has always ran and shifted fine till today. I backed it in to where i park it when i noticed that the pto arms were down. I lifted the arms and then the tractor would not move. I can shift between all...
    • ruger1
    • Thread
    • Replies: 0
    • Forum: Ford
  2. R

    Hard starting TO 30 in cold weather

    I did do that when starting. I think the original problem was the weak battery. Now that i have a new batttery the points or condenser are bad and it wont start at all. It definately turns over a lot better with the new battery than it ever did before.
  3. R

    Hard starting TO 30 in cold weather

    I checked the compression last year and it was 120 psi on all cylinders.
  4. R

    Hard starting TO 30 in cold weather

    I just went out to try the tractor and it would not start. I decided to check the spark again and i had spark at the coil wire and not at the plugs. I am assuming that the points or condenser are bad after removing the distributor cap and not having spark at the points. I am thinking that...
  5. R

    Hard starting TO 30 in cold weather

    I just checked the choke, it springs back when pulled out.
  6. R

    Hard starting TO 30 in cold weather

    0w30 in the engine. Im not sure about the choke, never had to use it before
  7. R

    Hard starting TO 30 in cold weather

    I have a '52 TO 30 that does not like to start in the cold. I have to jump start it in the cold if i want it start. After it runs for a few minutes it will start easily after that. I thought the battery was the problem so i bought a new battery with 700 cca and it still wont start. I push...
  8. R

    implement paint

    I just painted my Ferguson TO-30 with sherkem. You can see pics in the Harry Ferguson forum. Just search TO-30 pics. this was the first time painting anything with a gun. It's not show quality but came out pretty good i though. Its been very durable and only cost about 65.00 a gallon, no...
  9. R

    where to buy stud for block

    Does anyone know where i can buy a short stud for the block on my TO 30? One of my studs is partially stripped and i am worried about not being able to torque down the head.
  10. R

    engine hoist attachment points?

    Thanks for the reply. Thats how i wanted to do it but the head is removed also. I have a stripped head bolt that i was going to have the same guy repair while he welded up the block. Any way to do this with the head removed? Can i use the head bolts from the blockand lift in the same...
  11. R

    engine hoist attachment points?

    I am in the process of splitting my tractor and need to know how to remove the engine with the hoist. What is the best way to lift the engine block. I am having my block welded and need to move just the block.
  12. R

    Blocked cracked by starter, any way to fix?

    Does it matter if the tractor has a 6 volt starter on A tractor with a 12 volt conversion?
  13. R

    Blocked cracked by starter, any way to fix?

    It could have cracked from the first time the starter cone blew up inside the housing. I removed the chunks that were loose inside the first time. I figure after all the new parts i have put into the tractor i might as well fix it. The tractor runs great and the hydraulics are strong. I found...
  14. R

    Blocked cracked by starter, any way to fix?

    What size bolt will be sufficient for the bridge and how deep? What should i do about the lower hole that is split, should i try and close it up or should i leave it alone? Im not sure that the lower bolt will secure the starter if left as is.
  15. R

    Blocked cracked by starter, any way to fix?

    The tooth was broken lengthwise. There was no indication of binding at all when i started it several times earlier that day. I could hear it binding when it finally broke. I hit the starter twice and knew something was wrong, thats when it broke. Im a long way from nashville, i live in...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top