Recent content by russ springer

  1. R

    Brockway Truck VIN location

    look on the frame rail r/h side front in front of the rear hanger for the front spring
  2. R

    BROCKWAY

    are you sure of the model H260 or is it a 260 WH. look on the brockway web site maybe find one
  3. R

    59 B 61 MACK

    in 1959 B-61 had a hand operated emergency brake a handle on the floor operatted a brake on the rear of the transmission
  4. R

    air compressor for B-61 mack

    the compressor is driven with a fiber gear it could be the gear is cracked or loose on the compressor also could be the compressor but it sounds like the gear
  5. R

    john deere gx345

    thank you but i tried them and the replacement they have you have to leave the hood off the tractor
  6. R

    Collections

    i have a david bradley tri trac speedex s-17/s-19/s-17 square hood 1630 john deere minature a john deere styled a styled b unstyled a mt ar allis chalmers g/b/c luc john deere power unit
  7. R

    john deere gx345

    i have a 2004 gx345 john deere with an fd611v kawasaki engine.engine is bad but is discontinued. looking for a rebuilt or new engine. maybe a dealer might have one that needs to go
  8. R

    oil pressure

    i have a 35 b without a pressure gauge has only a plunger.i overhauled this engine a few years ago and it had pressure.the tractor sat over the winter and when it is started no pressure.is it possible for the plunger to stick it seems to move free.any ideas
  9. R

    b-61mack oil cooler

    the only mack engine that came with an oil cooler is a turbocharged engine. if you have good oil pressure with the spin on filters leave them on
  10. R

    B-61 mack part numbers.

    original numbers 98ax1853 speedometer 98ax1404 tackometer current numbers 54mt313bp94 speed 54mt314bp88 tack
  11. R

    paint

    looking to buy paint for an old mack engine blue/gray engine enamel
  12. R

    Drive Out License Tag

    put insurance on it.go to the dmv in whatever state you are buying it and get a driveaway plate good for 30 days
  13. R

    Mack Truck

    send me a picture and i will make you an offer
  14. R

    Heavy Truck Clutch Adjusting??? How to

    look up in the hole in the bottom of trans turn over engine until you see a small lock plate with a bolt holding it in place remove the lock and have someone hold the clutch pedal down you can turn the plate with a bar you do not need a regolar tool.to properly adjust you need 1/2"between the...
  15. R

    B-61 mack HELP

    the injection pump should have an oil feed line on the bottom side. the cap is a vent
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top