rustred's latest activity

  • rustred
    rustred replied to the thread Farmall M hydraulic problem.
    Yes I have seen bad couplers do that .
  • rustred
    rustred reacted to the tractior vet's post in the thread Farmall M hydraulic problem with Like Like.
    If it raises fine BUT will not drop change your couplers , BOTH of them . had that issue with my 706 way back drove me bonkers only did...
  • rustred
    rustred replied to the thread Ih 706 generator to alternator.
    Send me your generator ! I need a few of them. There is all kinds of alt. Conversion diagrams if you look them up. Very simple to start...
  • rustred
    rustred reacted to Jim.ME's post in the thread Ih 706 generator to alternator with Like Like.
    No, you don't have to remove all the generator and regulator wiring if you want a bunch of useless scrap hanging around as you have on...
  • rustred
    rustred replied to the thread Farmall M hydraulic problem.
    Are both hoses plugged in good ?
  • rustred
    rustred replied to the thread FARMALL MD.
    Better figure out a way to clean them oil galleries as that is one reason blocks get soaked before rebuilding. Least get it to a car...
  • rustred
    rustred replied to the thread Flat belt.
    Post a picture of this set up. We have nothing really for info here. Using a belt as long as possible is best. I use a 100 ft endless...
  • rustred
    rustred replied to the thread fuel or fool.
    Well we are over 10.00 a gallon.
  • rustred
    rustred replied to the thread fuel or fool.
    As true as the sky is blue !
  • rustred
    rustred replied to the thread FARMALL MD.
    Not sure what you’re getting at by using rust remover and soaking holes. The whole block gets a soaking overnight in a big tank. Plus...
  • rustred
    rustred replied to the thread FARMALL MD.
    And them old mains and rods should have been plastiguaged and the number wrote down so you actually know and have a reference on the...
  • rustred
    rustred replied to the thread FARMALL MD.
    How did u get them out. ? U need a cam bushing installer to install the new bushings. Or u just bash them out. Did u get the block hot...
  • rustred
    And also , on some lines you can cut the crimp off and install a new fuel line on them original fittings and just clamp them with a hose...
  • rustred
    rustred replied to the thread Sticky valve on a W30.
    If that valve was originally stuck due to rust and sitting there is nothing that will prevent it from sticking again. You can tap it...
  • rustred
    rustred replied to the thread Brake shoes.
    soak them in a pail of gas, then use brake clean. i have cleaned up some pretty oily brakes and they worked. you cant use wider shoes...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top