-
R
Wish I would stop doing this
I worked in an auto body shop, doing metal work and body repairs. I knew the dangers ssociated with the large hand-held grinders, that they could "catch" in between two doors, or the edge of a fender next to a door. Well, one day i got careless, and that 8 inch disc soon showed me the folly...- rusty j 14
- Post #1
- Forum: Tractor & Farm Talk
-
R
Make my own tie rod sleeve?
Does "Toe-in" matter that much when used on dirt? Also, could you weld a couple of nuts on the end of the tie rod sleeve, in place of the original threads? Keeping the threads aligned, so you can screw the tie rod end in or out? And, using a lock nut, or two together?- rusty j 14
- Post #1
- Forum: Restoration Processes
-
R
Electric fuel pump
Use a vacuum pump. Take the vacuum off the oil dip-stick tube, up near the cap.It DOES NOT PUMP OIL OUT OF THE ENGINE!Much easier, and much better than an electric one! RJ- rusty j 14
- Post #1
- Forum: Garden Tractors
-
R
Spray gun advice
Clean gun with laquer thinner. You will need about 45 lbs. of air pressure for spraying paints. Look where the needle goes into the back of the front "head" of the spray gun. One drop of 30 W. and some trigger pulling will probably cure the spitting. Do this wwithout the air hose being...- rusty j 14
- Post #1
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy