(800) 853-2651
SHOP NOW

Recent content by rustystuff

Yesterday's Tractor Forums
  1. R

    Help with Oliver 77 Row Crop track install

    Thanks for the help folks, much appreciated.
  2. R

    Help with Oliver 77 Row Crop track install

    Hi folks, Trying to help out a friend here. He has an Oliver 77 Row Crop and has purchased the track kit pictured for it. We don’t know who made this kit and also don’t have any literature explaining how to install it. Just wondering if anyone recognizes this kit and might have anything...
  3. R

    John Deere Model R wire diagram

    Agreed, but you identified the manual for me which I already found and ordered. I thank you both kindly
  4. R

    John Deere Model R wire diagram

    Thank you very much Jim.ME, this was a great help
  5. R

    Non stuck engine

    I’d put a spoonful of 2 stroke oil in each cylinder. It’s thick enough to hold some compression while the rings warm up enough to seal. Plus it’s designed to burn off in the cylinders and leaves minimal deposits that will just blow out the exhaust. Just my 2 cents, hope you get her fired up.
  6. R

    John Deere Model R wire diagram

    Hi everybody, I’m having to re-wire my R as most of the charging/lighting system wiring was removed when I bought it. I found this wire diagram in an older forum but it’s fuzzy and my eyes aren’t exactly what they used to be. Can anyone tell me what manual or website this diagram came from so...
  7. R

    Help identifying engine

    I think I have figured it out. I believe this to be a Lauson Frost King Jr. Either 1 3/4 or 1 1/2 hp is what these came as but without the data plate I don t know until I can get more info and measurements. I just came across a gas tank that I believe will fit so I should be able to try...
  8. R

    Help identifying engine

    Hi everyone, I have a new (to me) engine that I am having trouble identifying. No data plate to be found, but most cast parts (head, flywheels, block, etc) have an embossed "JR" with a coinciding number cast into the parts. Just hoping to find out who made it so I may find details for...
  9. R

    Briggs model 14 carburetor

    Excellent thank you!
  10. R

    Briggs model 14 carburetor

    Hi everyone, I m rebuilding a Bantam tractor for my daughter. I have the rebuild kit for the carburetor but it came with more seals and parts than what I can figure out. Does anyone have an expanded picture of one of these carburetors that shows all the internals and where all the seals and...
  11. R

    Cub cadet 1250 paint codes

    Thank you very much for that info, much appreciated.
  12. R

    Cub cadet 1250 paint codes

    Hi, I have a mid-70 s cub cadet 1250 that I need to do a little touch up here and there on the white and yellow. Anyone know the paint codes for that tractor? Thanks!
  13. R

    Bantam 3000 clutch assembly needed

    Yes I was very excited when I came across their website, that would ve helped me tremendously with this project. But after speaking with them and basically begging them to make a clutch I have lost hope. I know there s someone out there that has one of these clutches, hopefully this thread...
  14. R

    John Deere model R rear wheel needed

    I need to extend a very big thank you to David from Kansas. David has shared so much knowledge with me on this tractor and let s not forget that he was generous enough to basically give me a fantastic set of rear rims for my R. I have them at the COOP getting new tubes and should be able to...
  15. R

    Bantam 3000 clutch assembly needed

    I ve spoken with them multiple times and they re no longer making parts. So this is my life-line, really hoping someone out there has one they can spare.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top