(800) 853-2651
SHOP NOW

Recent content by shane12970

Yesterday's Tractor Forums
  1. S

    Water Pump Replacement Update

    Having same problem what is stud removal tool and where can i get one??
  2. S

    Long 360

    sorry it took so long to get back switch was shorted out. I got owners manual. is there any diagrams of the steering or a pparts manual. thanks everyone
  3. S

    Dan

    can you send ne the lift cylinder adjustment documents again. pc crashed and lost everything.
  4. S

    Long 360

    The starter switch . not the keyed switch . there is another thing that looks like below panel what is it for? thanks. . My FIL rigged everything . hes a crack head, hes on binge. any way he took battery out of tractor . Lost key and has a vehicle key in it.. I put battery in and wires started...
  5. S

    Bruce Va

    PostPosted: Sat Aug 16, 2014 2:11 pm Post subject: Re: Bruce Va Remove the #1 spark plug. (removing all of them makes the job a bit easier) Ignition off, place your thumb over the #1 spark plug hole and crank slowly until compression is felt. Continue to crank the engine until you see the...
  6. S

    Bruce Va

    Yes Bruce..Pulling out old one and putting in new one.. Royse. its a side mount 8n. Time 23 . thanks. Ive never done it so im hopping it goes smooth. Thanks all
  7. S

    Bruce Va

    just curious. are there any special tools I need to change out the distributor ? I read the manual and it seamed fairly simple. I also watch you tube video of some girl replacing one on a Jubilee.I will have a little extra money this month but because of kids school it will be tight. i was gonna...
  8. S

    no spark

    Its a good bit. It will be next month before i get the money. Thank you
  9. S

    no spark

    go out and not come back on... not on and off or blink.. Again I really appreciate the help. if it is dist. and i have to buy one ill need help on that too . but it will be next month lol money is tight this month and wife is fussing LOL. Again Thanks Shane
  10. S

    no spark

    Got light It would come on . buts heres the problem. 1. I think bushing is wore out. You can wiggle the shaft and pull it up about 1/4 to 1/2 inches.. I can put screwdriver between point and shaft and light wil come on.. if i push point up til light comes on then hit starter it will go...
  11. S

    no spark

    no i did voltage but want to make sure because meter is acting funny.. it was 1 volt from points
  12. S

    no spark

    Ok bruce here we go. apparently my Fluke is wrong on the resistance . I got another meter that i have. and here the readings on coil..Only differance is i have coil out of tractor. The fluke is reading wrong.. i checked spark plug wires with it and they are reading open. my other meter is...
  13. S

    no spark

    Im gonna re wire tractor first.i was reading up and from what you said i think. Ill do that. The coil at napa is like 80 bucks . I ohmed out. My sparl K plug wires and they wete all dif plus they have paint on them from prev. . Owners . Ill post results in a new post. Thanks shane
  14. S

    no spark

    I was reading up on coils. Isnt 9 ohms too much? I double checked ... that would mean only 1.3 amps going to points. If E= I X R.. where as if it was reading 4 ohms like ive seen its suppose to that would be a little over 3 amps Going to points.
  15. S

    no spark

    1. a to b 1 v 2. had spark but wasnt blue was more like when you light a bic. the orange sparks also did secondary test with plug and sparktester. nothing
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top