-
S
IH 404 Rear Hub Snap Ring Removal
Thanks for the info on the snap ring. Before I posted the first time, we broke one hub in a press, that was when we saw the ring. After dissecting the broken hub (cut it with a cutoff wheel and split it in 4 pcs) we found all the rust in the splines. The other one is now soaking in a bath of...- ShopteacherMN
- Post #6
- Forum: Farmall, International & McCormick
-
S
IH 404 Rear Hub Snap Ring Removal
Yes, #9 on the diagram is the problem. If I get a chance today, I will get a photo of it and post it. The thing that is throwing me for a loop is that there are splines all the way to the end of the hub, but the snap ring is 1/4 inch down in the spline (if that makes any sense) with no clear way...- ShopteacherMN
- Post #4
- Forum: Farmall, International & McCormick
-
S
IH 404 Rear Hub Snap Ring Removal
Just wondering if anyone out there knows how to remove the snap ring found inside the rear hub of an IH 404 (utility version). I have the axle pulled from the housing, but need to remove the hub from the axle to replace the outer bearing and seal and the IT manual is not much help. Thanks- ShopteacherMN
- Thread
- Replies: 8
- Forum: Farmall, International & McCormick
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy