Recent content by SkyePN

  1. SkyePN

    Thermostart system replacement?

    Interesting, I did a search and it doesn't sound like the Case intake heater is any more reliable: "THIS PART IS NO LONGER SUPPLIED FOR SERVICE. DUE TO UNAVAILABILITY OF PARTS, POOR SERVICE LIFE, AND POOR HEATING EFFICIENCY. NO ALTERNATE WILL BE OFFERED. NOTE: AN ETHER KIT MAY BE FITTED TO THE...
  2. SkyePN

    Thermostart system replacement?

    Is there a 12v electric intake heater element replacement for the thermostart system? I'm sure the thermostart works fine when it's working, but my MF 135 doesn't have the diesel return line plumbing for it, and I'd rather not have the possibility of leaks into the intake if the valve fails...
  3. SkyePN

    MF 135 updated wiring diagram?

    Making some progress What does (Wire Tapped) mean on the 12ga red wire going to the alternator? It's not connected to anything on the diagram? Maybe it's just a bad scan. Looks like I have a fat red wire going to R terminal with some tape on it.
  4. SkyePN

    MF 135 updated wiring diagram?

    My serial is 9A69515. I'm in Canada but I don't have any history on the tractor. Forgot the parts manual shows production changes, you're right p.152 of the parts book shows oil pressure switch on all models with some early vs late changes. So I have no idea why it's not on my wiring...
  5. SkyePN

    MF 135 updated wiring diagram?

    Looking again and I can't figure out the history, it has the 4 post voltage regulator like in the wiring diagram for alternator models, was the oil pressure switch a stock setup? Maybe I should just switch to an internally regulated 10SI alternator and simplify this whole mess, maybe add a fuse...
  6. SkyePN

    MF 135 updated wiring diagram?

    I think this must have been upgraded from a generator to an alternator because there's an oil pressure switch on the back of the oil gauge. I haven't traced it yet but I'm guessing it is or should be wired up to power Field on the alternator (or perhaps #2 on the voltage regulator). Did a...
  7. SkyePN

    MF 135 updated wiring diagram?

    I'm diving into the wiring mess in my diesel 135 (9A69515) and the Fig 62 diagram from the Owners manual for the diesel does not match the wire colours for my tractor at all... It also seems to be missing some things, for example my tach has an hour meter that is wired to something but...
  8. SkyePN

    Two sizes on tires, why?

    OK thanks. That chart says 14.9 needs a 13 rim but like I said in the original post I've done some searching online and I don't see 13 x 24 rims for sale anywhere, is it an odd size? This says the 12 x 24 rim is for 13 x 24 tires so is that using the old tire sizing and it's good for the...
  9. SkyePN

    Two sizes on tires, why?

    Need to replace the rusted out rims on my MF 135, but my tires are marked with two sizes: 14.9/24-13/24 Can't find any info on why two sizes would be shown? Below those it says "on W13 rim" Is the second size the rim recommendation? I can't find any 13/24 rims, 535454M91 says it's for...
  10. SkyePN

    Loader float, now it''s not working

    Forgot to mention the drive shaft does turn when the tractor is running, so presumably the pump would work again if I can get a new shaft and key installed. However it rotates off center in the housing hole. Not sure why the key sheared off in the first place but the eccentricity can't be good...
  11. SkyePN

    Loader float, now it''s not working

    Snow has finally melted enough so I can dig out the 135 and have a look at the loader. Wasn't getting any fluid out of the front PTO pump so I pulled it out, and surprise, the shaft key was all mangled and sitting at the bottom of the housing. The pump shaft looks a little mangled, maybe even...
  12. SkyePN

    Loader float, now it''s not working

    Fluid is clean but has some froth on top, this tractor is fairly new to me so it's possible there was ice somewhere that has clogged the system. Thanks for the checklist I'll start working through it after I dig out. Might have to wait until spring - discovered the diff lock doesn't work...
  13. SkyePN

    Loader float, now it''s not working

    Fired up the 135 today to clear some snow, I have a MF32 loader attached with its own dedicated pump at the front. Things were working well, then I thought I'd try the float function on the controls to scoop up some snow (arm control all the way forward) But when I turned off float, none of...
  14. SkyePN

    Alternator Wiring

    Glad you got it worked out. I'm having the same problem now (battery overcharging). Did you go with a modern solid-state regulator replacement or an original electro-mechanical type? Going to pull my voltage regulator apart and try cleaning the points.
  15. SkyePN

    MF32 loader fluid?

    MF 32 owner's manual arrived in the mail today. The official recommendation is M-1110A [/img:d6586ff9c3]
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top