(800) 853-2651
SHOP NOW

Recent content by slcullen

Yesterday's Tractor Forums
  1. S

    75 Tip index

    Not being able to post a PDF file with the index, here's a cut and paste that I hope can be copied. Anybody want to improve it in any way, please do. And after paste it in this reply, it's not a neat as the PDF file. And a second thought, it you'd like to e mail me at [email protected]...
  2. S

    75 Tip index

    I've used the tip list for some time and am very thankful for it. I recently did a lot of repair to my side distributor 8N and the list was helpful several times. Having to scan a lot of items to find what I needed got me to thinking it would be nice to have an index for it. So I sat down last...
  3. S

    Fan blades hitting shroud

    Finally got back to the fan problem after spending a week with a muscle spasm in my back. Wound up removing the fan and grinding the tips of the blades. Installing the fan and without the hood attached, it ran with absolutely no fan hits at any RPM speed. However.......with the hood attached...
  4. S

    Fan blades hitting shroud

    Thanks gentlemen. All I've been able to do since posting is to check the fan blade for wobble. It's nice and tight. So as soon as I can get some help, I'll take off the hood and see where it's hitting. Can't tell with a flash light. Will post an update when I've done that. And since I...
  5. S

    Fan blades hitting shroud

    Late model 8N. I bit the bullet last week and replaced the front axle pin. A job getting it out, but got 're done finally. Took it for a brief drive and no problems. Attached the mower and after hitting a fairly shallow dip, I heard the fan blade hit the shroud lightly. Continued mowing...
  6. S

    8n Hydraulics

    Thanks Bob, and also Ohiojim re soaking the leather seal. I had thought the oil passage way might be through the end casting but could not find any reference to it anywhere I looked. Will probably be next week before I can take the lift cover off, and all post what I find when I get it off.
  7. S

    8n Hydraulics

    I'm going to replace the hydraulic cylinder and piston in my 8N, side mount distributor. I've been looking at the manuals and on line sites about how to do it. I'm confortable with everything expect two things: the oil tube, and soaking the leather ring in water. It seems wrong to soak it in...
  8. S

    8n differential leak

    Thanks for all the help gentlemen. I"ve gone the J B Weld route and so far so good. I hesitated to drill a stop hole. Are the chances high of getting metal shavings from the drill bit into the hydraulic fluid? Merry Christmas to one and all!
  9. S

    8n differential leak

    Season's greeting ladies and gentlemen. My 8N has a two inch hairline crack in the bottom of differential case and is leaking excessively. It's not pouring, but much more than I want on the shop floor. At first I thought it was the PTO seal, but cleaning it up has revealed the hairline...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top