Recent content by Smidkiff

  1. S

    John Deere 2010 hydraulic pumps

    You are correct... The challenge factor is a major part of being a good machinist. The machining on the pump isn't really the challenge for me, I don't think. I think the challenge comes in for me because so many people say that the pumps are non-repairable. As a job shop machinist, that just...
  2. S

    John Deere 2010 hydraulic pumps

    I was thinking about making a new body and then machining pockets in the top and bottom housings and making replaceable inserts. That would make the pumps better than new, if I'm thinking correctly. I'm thinking that once that I get everything figured out that the actual machining time should be...
  3. S

    John Deere 2010 hydraulic pumps

    If you are referring to the middle piece, between the inner and outer housings, there are actually a few different ways to do that. In my opinion, the easiest way is to just make a new one. The parts material is soft so it will wear rather than the gears. As long as a person follows that theory...
  4. S

    John Deere 2010 hydraulic pumps

    In mine the gears show no wear. The bronze bushings are what has worn and let the gears get into the housings. My thoughts are, to make inserts for the top and bottom housings and remake the center piece that the gears ride in. The gears are harder than everything else in the pump, so they...
  5. S

    John Deere 2010 hydraulic pumps

    I'm a machinist and have worked in job shops for about 25 yrs. There's not too many things that I've seen that couldn't be repaired unless they were completely destroyed. With that said, I have a 1965 John Deere 2010 that lost it's pto. After tearing it down, I found out that the pin in the...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top