(800) 853-2651
SHOP NOW

Recent content by solitairenc

Yesterday's Tractor Forums
  1. S

    Loader controls

    I'm having the same issue with AGCO as far as parts go. I have a M-40 with a M-34 loader and the spooler valve for the dump has gone bad. Not one to be found. I'm going to have to make a plate with inlet hole and getting a double end threaded pipe to dump the oil back into the frame rail. Would...
  2. S

    m 40

    No they don't . Thinking ground but going to check today. Should be hot wire to each bulb and tractor as ground but fenders may not be grounded.
  3. S

    m 40

    Looking for a wiring diagram for a M40. Can't get the lights to work even after replacing all the switches and wires. Hmmm..
  4. S

    ID and brakes

    Thanks.
  5. S

    ID and brakes

    I don't' have manual, where do I find one and what would it be called?
  6. S

    ID and brakes

    That is it. There was spring (garter spring) that fits over the inner seal wall after the seal is slid over the yoke. I saw one disassembled and it was there. I've found them online from a manufacture and needed info was the dimensions of the old one that was gone. They had put the wrong...
  7. S

    ID and brakes

    Does anybody know if there's a tiny round (ring) spring that fits on the boot after you put it back on the actuator shaft, saw one on the install video but cannot find it or a picture or a part number and the dealers are lost also.
  8. S

    ID and brakes

    It's what is listed as oil seal for actuator shaft so I guess it keeps dust and oil in or out but fails miserably at both at present. The part that goes in side has a metal sleeve around the edge that fits it in and is driven in by a mallet and 1 1/4 socket which works really well. I've order...
  9. S

    ID and brakes

    Thanks. I've been ordering OEM stuff but guess they don't make um like they used to.
  10. S

    ID and brakes

    Understood everything but seal bore ID?
  11. S

    ID and brakes

    Got a MAssey 40 I think, it has a m34 loader that in my humble opinion is overbuilt. But the serial number is 9A235987 for the tractor and L811011493 for the loader. The problem is with the wet brakes. It was leaking fluid because the seal was GONE and I mean gone. I order two the first being...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top