Recent content by SoulFate15

  1. S

    Farmall H 12 volt live hydraulic wont start

    I moved the sparkplugs two positions so that the firing order matches up with the distributor being out 180 degrees. There is a lot less backfiring but its still backfiring often. I have checked the valves and none of them seem stuck but at the same time I have never worked on valves so im not...
  2. S

    Farmall H 12 volt live hydraulic wont start

    What I meant was i was confirming that the piston was coming up (compression stroke) and I used a straw through the sparkplug hole to feel the piston come up to verify. I then turned the crank pully to the tdc mark. I apologize as I'm only 22 and still very new around this type of equipment...
  3. S

    Farmall H 12 volt live hydraulic wont start

    Everything Ive read has said that the distributer turns clockwise and that the firing order therefor follows clockwise, My specific H was converted to live pto and the distributor is now driven via a hydraulic pump shaft passing through the distributer housing and into the magneto housing. Im...
  4. S

    Farmall H 12 volt live hydraulic wont start

    I used a piece of plastic and verified that the piston in cylinder 1 was at the top of the stroke, is that not enough? How do you check the valve Trane?
  5. S

    Farmall H 12 volt live hydraulic wont start

    Firing order is correct. How do I check the valve settings? This post was edited by SoulFate15 on 06/03/2022 at 09:21 pm.
  6. S

    Farmall H 12 volt live hydraulic wont start

    https://forums.yesterdaystractors.com/viewtopic.php?p=10562905#10562905 I am now almost 90% certain that I am in time close enough to start. I manually turned the crank pulley with a wrench with a finger in the number 1 spark plug hole and waited till I felt air push out so I knew I was on...
  7. S

    Farmall H 12 volt live hydraulic starter whirring and oi

    Any ideas? Can I send videos on here?
  8. S

    Farmall H 12 volt live hydraulic starter whirring and oi

    A couple of days ago I cleaned it out and man was it nasty! I put new oil in it and that seems to have fixed the issue of the oil spewing out. Yesterday I double check the timing and double checked for spark in each cylinder and I can confirm we have strong spark and that the firing order is...
  9. S

    Farmall H 12 volt live hydraulic starter whirring and oi

    When the h came into my possession it was bone dry when it comes to fuel. I had put brand new fuel in and I had already taken the carb bowl drain plug out and I have good fuel flow coming from it. I will have to check the oil bath for water as that was not something I was aware of. Is the oil in...
  10. S

    Farmall H 12 volt live hydraulic starter whirring and oi

    When the h came into my possession it was bone dry when it comes to fuel. I had put brand new fuel in and I had already taken the carb bowl drain plug out and I have good fuel flow coming from it. I will have to check the oil bath for water as that was not something I was aware of. Is the oil in...
  11. S

    Farmall H 12 volt live hydraulic starter whirring and oi

    Thanks Jim! I apologize as I didn't see your first comment until now. Could the oil spitting up from the air stack (not sure what its called) be caused by the incorrect timing and backfiring? I'm afraid to keep trying to start it and to keep messing with the timing with the oil spitting up like...
  12. S

    Farmall H 12 volt live hydraulic starter whirring and oi

    I should also mention that when I purchased the H the distributor was not attached. I manually turned the crank pulley with a wrench with a finger in the number 1 spark plug hole and waited till I felt air push out so I knew I was on the compression stoke, I then turned it to top dead center and...
  13. S

    Farmall H 12 volt live hydraulic starter whirring and oi

    Hey everyone, first post here. I recently Bought a farmall H that that has been converted over to 12 V with live hydraulics. When I bought the H it wasn't running and the the crank pulley was stuck. I freed up the crank pulley several days back and and sprayed some WD40 in the spark plug holes...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top