(800) 853-2651
SHOP NOW

Recent content by spritzer1

Yesterday's Tractor Forums
  1. S

    Newbie safety question

    I know others have said "go slow", probably meaning travel speed. But don't throttle down too much or it will take more power to cut the growth. Rather, go slow--use good engine speed, and maybe take only half a swath at a time. If growth is tall, a second time over would chop up the material...
  2. S

    Asphalt Millings for a driveway

    I live in a semi-rural area where we have an association of 14 homeowners. The private road is about 6 tenths of a mile. We've used gravel and crushed limestone, but have had LOTS of dust. Especially if they didn't observe the 15 mph speed. SO---we tried crushed/re-cycled asphalt. Didn't get the...
  3. S

    Straightening 1 1/2 inch thick steel?

    If you have an AC welder, 225 amps, get a carbon arc torch to use with the welder. Torch shouldn't cost much. Arc flame produces about 10,000 degrees, whereas acetylene flame is about 6000 degrees. Then bend until alignment is made. Might be easier than veeing and welding.
  4. S

    m Farmall backfired

    Shoot me an e-mail---Need your help.
  5. S

    Road building

    Sorry--No picture---
  6. S

    Road building

    Try something like this------- Use 3-pt. w/drawbar & receiver hitch with ball. Uses hydraulics for tilt control.
  7. S

    Restore scratch wheel aggression?

    Simply remove the wheel, turn it over, and replace it.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top