-
Opinions Solicited
I really like my SawStop. I bought it because I have 5 grandkids close, and wanted the added safety. I got a little careless and verified that it works as advertised. Only in bright light and under close scrutiny could I see where the blade hit me. I would think a foot switch for a tablesaw...- Square Eye
- Post #9
- Forum: Tool Talk
-
-
RACOONS IN THE BARN
This. Use miniature marshmallows as bait. Drop two or three in it and scatter a few around it.- Square Eye
- Post #32
- Forum: Tractor & Farm Talk
-
OT-Roadside Assistance when Towing
Nancy is not back. Her post was in 2010. This is an old thread.- Square Eye
- Post #26
- Forum: Tractor & Farm Talk
-
-
-
TSC Store
I think he was referring to Kentucky Gardener who is in his early teens.- Square Eye
- Post #33
- Forum: Tractor & Farm Talk
-
Trencher/ Excavator/ Digger
So, it uses the same engine as Wonder Woman’s plane? Neat old piece of equipment, though.- Square Eye
- Post #4
- Forum: Tractor & Farm Talk
-
End of the Backhoe/Loader?
I have watched that being done a number of times, and still do not know how they can climb those things up there like that. It fascinates me.- Square Eye
- Post #23
- Forum: Tractor & Farm Talk
-
Birch plywood pitfalls
Not just birch! Cabinet grade plywood in general has very thin outer ply, be it birch, oak, maple or whatever. It is a better move to strip first, then lightly sand. Even then, do it carefully.- Square Eye
- Post #2
- Forum: Tool Talk
-
Another bandsaw question
I use 3/16” for products such as bandsaw boxes up to the max my Craftsman saw will take - 1/2”, for work like resawing. Of course, each blade change requires resetting the guide blocks and thrust bearings. You may also need to adjust the upper wheel for proper tracking. The slot in the stub on...- Square Eye
- Post #6
- Forum: Tool Talk
-
PT2 brush painting tractor
If that power cord that’s looped over the handle is for that compressor, then it most certainly is not a 5.5 hp unit. The plug looks to be for 120v single phase. They must be using the shop vac system of rating hp.- Square Eye
- Post #8
- Forum: Tractor & Farm Talk
-
Looking for Sarge
I can’t speak for other states, but Texas has County Veteran Service Officers. The one in our county has an office in our county court house. He submitted everything needed to get the ball rolling. All he asked of me was a copy of my DD214. It was on file in the county clerk’s office, so it was...- Square Eye
- Post #12
- Forum: Tractor & Farm Talk
-
-
Unusual wood crate parts (?)
That sounds like a sliding dovetail.- Square Eye
- Post #10
- Forum: Tool Talk
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy