Recent content by Steve Foster

  1. S

    flojet carb problems

    Thanks. I'll look for those, clean them, make sure they're freed up. However, whatever the problem is, it is apparently resolved by removing it, opening it, cleaning it, and reinstalling. Can't understand why it runs when first reinstalled, but not two days later, three times in a row.
  2. S

    flojet carb problems

    This is on an 11hp B&S I/C flathead, in a walker riding mower, bought used. Carb leaked badly, so bought one off amazon (chinese, of course). Was surprised, as it ran well for about ten hours of use, then behaved as though it wasn't getting fuel. Took the carb apart, cleaned and replaced...
  3. S

    MF 30b 3 pt hydraulics problem

    Yes, there is a pressure port on the side of the transfer cap. That's discussed in the service manual. I'll pick up a 5K gauge and ck that. However, after going back and cking it again w/o starting the engine, I think it may be the control linkage. When I watch the control lever through...
  4. S

    MF 30b 3 pt hydraulics problem

    This is a MF 30b Industrial w/ loader and box scraper/scarifier on the back, no pto, that I acquired in the present condition. When I bought it, the 3 point lifted enough to get it on the truck, which it will not do now; it was about 20 degrees cooler then. When I start it up and engage the...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top