(800) 853-2651
SHOP NOW

Recent content by steve(MI)

Yesterday's Tractor Forums
  1. S

    AC 400 series cultivator

    As a follow-up it would help to know the length of the front rod as well as the length of the rear rod. Since this was originally on a D17 the length of the front rod will be longer than what would have gone on the D14 so length of both would be beneficial. I am assuming I have #6 for the D17...
  2. S

    AC 400 series cultivator

    I recently purchased a 400 series cultivator for my D14. Most everything was there except for two of the lift rods so I am going to have to fabricate them. My question is how long were they? The parts manual shows part# 332382 and it appears to fit both the 200 and 400 series cultivator. Only...
  3. S

    cultivator question about row spacing

    No power steering but that’s not a problem. Grew up on a WD45 with no power steering. I also have a set of disc hillers that I can swap out for the front sweeps. Previous owner had setup for hilling up rather than barring off. Had to look that term up as I never heard it before . I don’t have...
  4. S

    cultivator question about row spacing

    Right now it’s set at 10 inches for each row. I did that before searching the net just based off memory. I have to slide everything 1 inch closer to the frame because it’s set for 32 inch rows. When I double checked the planter it was set for 30.
  5. S

    cultivator question about row spacing

    I rode many hours behind a cultivator growing up but paid no attention to this and dad’s gone so I can’t ask him
  6. S

    cultivator question about row spacing

    Thanks Paul The one i bought was set up for much wider rows, For what it’s worth I searched on the net and AI (not that I trust that) said 3-5 inches outside the row, translated to 6-10 inches total width for the inside of the sweeps. Without more that’s where I will start.
  7. S

    cultivator question about row spacing

    I just purchased a 400 series row crop cultivator to mount on my D14. My question is how much spacing to you set for the row? The manual shows where to place the first gang but does not suggest a width for the row. I will be planting corn in 30 inch rows.
  8. S

    Oliver OC4 Ignition conversion

    Does anyone know if there is an electronic ignition conversion for the OC4, 3 cyl gas? and does it remain 6volt rather than converting to 12?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top