(800) 853-2651
SHOP NOW

Recent content by Stevemf20

Yesterday's Tractor Forums
  1. S

    Dynamo disaster

    Thanks TimMiller, much appreciated matey. Steven
  2. S

    Dynamo disaster

    Thanks, is there an easy way to test ammeter and fuel gauge?, thanks.
  3. S

    MF 135 Fuel Gauge

    Hi, sorry to hijack your thread, i was just wondering if it was normal for a 135 fuel gauge to only register when at 1/4 throttle and above, when i tick over my gauge reads 'E', thanks
  4. S

    Dynamo disaster

    Would it be possible for the fuel gauge or ammeter to cause problems if either of the gauges themselves were faulty i.e. shorted inside etc?, just a thought.
  5. S

    Dynamo disaster

    Thankyou MHMalcolm, I have a wiring diagram with the owners manual and everything is definately where it should be, i'll keep head scratching, thanks for your views, much appreciated.
  6. S

    Dynamo disaster

    Thanks again, my 135 is a Perkins diesel, but it looks as if the gauge is just mechanical, so does that suggest that the charging is linked to the ignition switch instead of the oil pressure switch?
  7. S

    Dynamo disaster

    Hi, just had a look at the back of the gauge and there doesn't seem to be any switch on it, it only has single oil line from the block going into the centre of the gauge, just to clear up tractor is a 1976 MF20 industrial uk model (similar to 135), does this make any difference?, another thing i...
  8. S

    Dynamo disaster

    I didn't think the gauge had electronic cut out switch so i'll check.
  9. S

    Dynamo disaster

    Hi, my 135 stopped charging around 18 months ago so i fitted a new dynamo and regulator and all seemed fine, about 10 hours work later and the dynamo failed, we thought it was a dynamo fault so fitted another and all seemed ok, then about 5 hours work later the new dynamo failed so we put it...
  10. S

    135 Engine rotation.

    Hi David, sorry to be a pain but i have been pondering this bloody thing all day, thanks for the info on the tappets, can i torment u with a couple more questions, i removed the timing cover to fit a new seal and noticed that the timing cover has a little spring (tang) that pushes against the...
  11. S

    135 Engine rotation.

    DavidP you are a legend, just to confirm when tractor is running the fan turns clockwise looking from the front, also the timing window doesn't have a pointer in it as suggested in the book would i be right in thinking that the tdc mark should just be in the centre of the window?, finally can...
  12. S

    135 Engine rotation.

    Hi, could someone please tell me which way the engine rotates on a 1976 Massey 135 diesel, i set the tappets yesterday by turning the fan clockwise from the front not thinking it would make any difference, if looking at fan from front is anti-clockwise would it make any difference when setting...
  13. S

    Deutz 8006

    anyone?
  14. S

    Deutz 8006

    Does anyone know the bleeding procedure for the hydraulics?, thanku
  15. S

    Deutz 8006

    Hi, could anyone help me with a few old 1976 Deutz 8006 questions, 1), What is the easiest method for bleeding back brakes as these tractors have a balancing valve across the two master cylinders and four bleed nipples? 2), Are there any common hydraulic faults as the hydraulic arms dropped all...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top