Recent content by Sum~Guy

  1. S

    MF Combines (300, 500, etc) 1960's to 70's differences

    I'm looking for a simple explanation for the similarities and differences in the Massey Ferguson combines from the mid- 1960's to I guess maybe the end of the 1970's. I want to know what models would share similar parts to my MF-300 combine (it has slant-6). The engine I can take care of...
  2. S

    Massey 300 Combine - should BOTH wheels spin in neutral?

    Can this be done from the back side (ie behind the wheel)? I see there are bolts I can access on the drive housing? In other words, can I do anything useful without taking the tire off? It will be a major job just to stabilize the combine and take the wheel off. And - are these disk...
  3. S

    Massey 300 Combine - should BOTH wheels spin in neutral?

    I've been putzing with an old MF 300 combine that's been sitting in a field for a few years. Had to make a puller to pull the clutch, man was it rusted inside. I've jacked up the combine so the wheels are off the ground. If I put it in neutral I can spin the left wheel by hand, but the...
  4. S

    MF 300 combine - is this a good place to ask questions?

    I'm helping a friend with a late-60's Massey Ferguson 300 combine. Is this a good place/forum to ask questions, or is there a better place? Edit: I think maybe this is why I can't seem to put the combine into gear: https://www.youtube.com/watch?v=3wXm-ngZtkM It has been sitting for 4...
  5. S

    Schebler carb differences between TE/TO 20 vs 35

    I've received the Schebler carb and see that there is not enough room under the mounting flange for one of the nuts from the intake manifold studs. So I can't simply drill out the existing holes in the carb flange. I'm now going to make a couple of plates out of aluminum, bolt one to the...
  6. S

    Schebler carb differences between TE/TO 20 vs 35

    There seem to be a few different Schebler-looking carbs available for the TE-20 and TE-35 tractors. I'm only interested in knowing about the Schebler carbs, not the Zenith carbs. A short (and probably incomplete) list of the stock or model numbers for these are: 533969M91 181532M92...
  7. S

    Modifying Schebler "Marvel" carb to fit TEA-20

    I'm in London Ontario. BTW, should I have started this thread here (in Massey Harris & Massey Ferguson) or in the other group (Harry Ferguson) ?
  8. S

    Modifying Schebler "Marvel" carb to fit TEA-20

    I haven't come across any NOS or reproduction Holley carbs for sale, but I haven't specifically looked for them. I have read that in Australia any TEA-20 that came with them were quickly changed to (I guess) the Zenith (ie - the Holley's were not great). In Canada I get the impression that...
  9. S

    Modifying Schebler "Marvel" carb to fit TEA-20

    The TEA-20 has a manifold with stud-spacing of 62mm for the Zenith carbs. New Zenith carbs are expensive, there is a reproduction Zenith carb, but it's still expensive (about half the price). The Schebler carbs (or a reproduction of them) cost about $40-$50 but they have a flange hole...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top