-
S
PTO speed on Ford 7700
The bearing retainer for the PTO if it has bolts at 12 and 6 O clock and 2 and 10 you have a single speed. If there 2 on each side it is a 2 speed. -
S
Opinion on 841 diesel
Watch Oil pressure when warm. The hundred series motors only had 3 main bearings and Ford put very hard bearings in the diesels usally when need to be replaced the crank needs to be turned. -
S
Ford 9600 8600
Did they replace the clutch when they had it apart. My 6600 made a ratling noise at an idle before the rivets in the clutch disk gave up. -
S
Meaning of BELT HORSEPOWER?
Belt pulleys were much more common on early tractors than PTO. -
S
Good Loader Hunting - Ford 5610, 777B
I had a 6600 bought new in 1981 with a 777D loader and no ROPs. The QT loader rear mount goes on the trans-clutch housing. -
S
3 cylinder steering wheel puller
I've always use one of those bearing separator type pullers like you use in a press. -
S
wire orientation
Looks like the top one is number one. Clockwise 1-2-4-3. If I'm wrong and it's counterclockwise swap numbers 2 and 3 -
S
Sunbeam...Is this the alternator?
Yes that is the unit. I have used the on 5000s make sure your Tach swings clockwise. You will need a regulator. The regulator terminals F 1 2 3 F to F, 1 to R tie 2 and 3 together and go to ignition switch. Gas tractors may need a diode in the 2-3 wire. -
S
Priming Ford 600 800 piston hydraulic pump
Try getting the front of the tractor lower than the back as in putting it in a road ditch.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy