Recent content by svrunyan4075

  1. S

    It's been 7 years, is All State Ag Parts still dependable on quality?

    Thanks everyone for sharing - once again - your experience with All State Ag Parts and any additional thoughts you may have. @Bob Bancroft I'm not exactly certain if there is a dealer close to order from A&I. But that is one thing I didn't think of trying. I may need to research that out for...
  2. S

    It's been 7 years, is All State Ag Parts still dependable on quality?

    I'm needing to purchase a Dual Stage Clutch for my John Deere 790. I've seen here in 2016 and 2018, members were happy with All State Ag parts. Do members here still feel the same after 7 years? I've read complaints about service but not about parts. Honestly, I was going to go with Hy-Capacity...
  3. S

    Hi cpratt! I haven't been here for a while but I logged in to look at some Tractor Parts and...

    Hi cpratt! I haven't been here for a while but I logged in to look at some Tractor Parts and prices, and I receive a Forbidden that I don't have permission to access message. Can you help with that? It seems I can access everything but that. Thanks!
  4. S

    Is there a wiring diagram for 12v conversion kit?

    Oops, missed the connection between the starter coil and the starter button.
  5. S

    Is there a wiring diagram for 12v conversion kit?

    JMOR and Royse: Thanks for the replies. I like JMOR's suggestion of a 'NET' reading diagram, I wasn't sure which to choose of the diagrams. I attached a diagram of what exists which I thought might help. I do have pictures I could still provide, they just didn't show end-to-end. I...
  6. S

    Is there a wiring diagram for 12v conversion kit?

    Thanks, this is helpful. I have what looks like possibly 16 and 12 gauge wires. These wires aren't labeled, so I won't know for sure if they are wired correctly. Is there a specific diagram that comes with the kit available? In the end I understand it may be my best guess but just checking...
  7. S

    Is there a wiring diagram for 12v conversion kit?

    Is there a wiring diagram available for the 12v Conversion Kit? When I bought my 8n, it was already wired as a 12v, but looks like amateur Radio Shack wiring. I bought the 8NE10301 wiring harness which is part of the kit. I know there are different way to wire a 12v, but I was hoping for some...
  8. S

    Stuck on two issues: Alternator 0 amps / Battery Sparks

    Thanks everyone! It was both the battery and battery cable. My battery was under warranty so it was replaced for free. I put a new battery cable on it last year and bought it from Walmart, but it had the cheaper connector, which I was skeptical of and probably was my primary cause. So, I...
  9. S

    Stuck on two issues: Alternator 0 amps / Battery Sparks

    I found it! Thanks for the suggestion I'll try that and post the result
  10. S

    Stuck on two issues: Alternator 0 amps / Battery Sparks

    I'm having a hard time finding what the proper gauge cable sizes for the Ford 8N would be you happen to know what that is?
  11. S

    Stuck on two issues: Alternator 0 amps / Battery Sparks

    I have two issues I'm stuck on. 1. When I turn the key on and push button start the battery's positive post sparks. 2. I've replaced the alternator (3 pole) for the tractor and it ran great with as much as 30 amps for the first couple days. Then the next couple times at 15 amps then...
  12. S

    Need 2nd opinion starter switch is bad

    Awesome! Thanks for taking the time to reply.
  13. S

    Need 2nd opinion starter switch is bad

    If I turn on my key and bypass the ground on my stater button with a screwdriver, my tractor will start. Otherwise, if I just push button, I will get a quick pop noise and then nothing happens. I know it may seem obvious, but I would like a second opinion if any cares to reply. Thanks! Scott
  14. S

    Ford 8n: bushhog bogged down and tractor stopped - won't sta

    These are good suggestions. All the electrical is new (Wiring, alternator, spark plugs, solenoid, battery, starter, etc - except push button switch and key). I realize anything can happen but I use this tractor and have been through all those issues before and check them first and regularly...
  15. S

    Ford 8n: bushhog bogged down and tractor stopped - won't sta

    My bushhog got bogged down and stopped the tractor. It wasn't a sudden stop but slowed to a stop within a couple seconds. Afterward it wouldn't do anything when I turned the key. The solenoid wouldn't click and the starter wouldn't crank. Battery is brand new and fully charged Solenoid is...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top