-
S
YM2000
Winston; Those cylinders on your Yanmar are exactly the same as mine. I really appreciate all your trouble. Swede- Swedemd-HT
- Post #1
- Forum: Yanmar
-
S
YM2000
Winston; I appreciate your f/u on the cylinder problem. The bore is 2 inches and the stroke is 12 inches. The pin size is 3/4 in(19mm) and I'm not sure what the operating pressure is but those figures sound reasonable. The extended length is 33 inches. My problem has not been finding the...- Swedemd-HT
- Post #1
- Forum: Yanmar
-
S
YM2000
The end cap apparently loosened and I didn't realize it and when I tried to use the bucket, the cap blew off and, according to to hydraulic shop, splayed out the end of the cylinder and it can't be repaired. I have tried mutiple cylinders of that size but pin tubes are too wide to fit the...- Swedemd-HT
- Post #1
- Forum: Yanmar
-
S
YM2000
I have a Yanmar 2000 with a Bulldog 285 loader. I recently had a failure of the bucket cylinder. The hydraulic shop is not able to repair the cylinder and I have searched all over for a replacement cylinder but have been unable to find one. Does anyone have a source for replacement parrts for...- Swedemd-HT
- Thread
- Replies: 20
- Forum: Yanmar
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy