(800) 853-2651
SHOP NOW

Recent content by tachnem

Yesterday's Tractor Forums
  1. T

    Still not running update

    Make sure your float isn't bent. Mine was bent and hanging up on the sides of the carb. Straightening it out took care of it.
  2. T

    External cylinder running of internal hydraulics?

    Do you sell the fill plug return port fitting? Looks great!
  3. T

    Live hydraulics and using trans sump for crank driven pump

    I have a crank driven hydraulic pump and would like to plumb it into the transmission/rear axle sump. Will I need to drill and tap or are there already supply and return ports I can plumb into? Is that too far of a run for the supply line to the pump? If I understand correctly, after doing...
  4. T

    Sherman combo input shaft

    Thanks. It seems my PMs are disabled and I don't see an email address in your profile. Because I'm new I guess. Any other way to get ahold of you? Perhaps you are able to message me? Definitely interested. Thanks, Sean
  5. T

    Sherman combo input shaft

    Great info, thanks!
  6. T

    Sherman combo input shaft

    So if I were to get the following clutch kit I could run the 15 spline combo box in my 8n? And the input shaft length and the location of its splines would work in the 8n bellhousing? http://www.external_link/ford_clutch_601_801_2000_4000.jpg Thanks for your help!
  7. T

    Sherman combo input shaft

    I picked up a sherman combo this morning with the 15 spline input shaft. Can I run it in my 52 8n by just swapping to the 10 spline input shaft? Any other mods necessary? Anyone know where to get the 10 spline input shaft or if anyone would want to trade? Thanks! Sean
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top