Recent content by TammyK

  1. P

    ARP rod bolts?

    Anyone have a good alternate source for rod bolts for the IH 6 cylinder gassers, there over $50 a rod at the dealer, thats nuts!! This is a 263 in a 560
  2. S

    1936 McCormick-Deering 10-20 Value?

    My neighbour has a McCormick-Deering 10-20 sitting next to our boundary fence. He put it there as a garden ornament. Sheetmetal work is terrible, it has an Oliver main fuel tank on it, petrol tank rusted through, missing hood assembly and wheel lugs are worn. The motor can be turned with...
  3. F

    JD 4240 alternator

    Having problems with Delco alternator. Put in new parts etc. What is the purpose of the capacitor? It is causing the alt to short out. JD parts does not show it in the parts book. Is there a number for it some place else.
  4. W

    Shopping a used Deere 2555

    I have a line on a used 1988 2 wheel drive 2555. I have not inspected the tractor yet and thought I would ask the board if there were any unique issues to look for when shopping this model. The unit has 3900 hours and appears to be in pretty good condition. No significant body damage and the...
  5. B

    Admin - Same thing

    Went to reply to a post and got the 'sign in thing'. Don't remember my password and stuff, been here a while.
  6. J

    8N squealing near alternator or water pump.

    My 8N sounds like a cat fight up front. Not sure if it's the belt, the water pump or the brand new alternator I just put on it. It did not make this squalling noise until I put the new alternator on. However the old alternator wasn't working. It would squeal for a few seconds then quit. Now it...
  7. K

    Farmall M Fire Crater Carburetor Changeover Question

    Working on a 1947 M and have installed NOS Fire Crater pistons along with Fire Crater distributor changeover parts to change the advance. Next to install are Fire Crater carburetor changeover parts. The brass tag on the carburetor has P/N 50983DC. Fuel bowl casting has P/N 6514DA cast in...
  8. K

    New Holland Baler..........

    Hello out there , Im looking for "advice" on using a New Holland 276 Baler ; Im wanting to buy a John Deere "B" tractor to run this baler but thinking I may want an "A" tractor? Is there enough "horsepower" in the "B" to run a 276 baler? Thanks.
  9. T

    Case 442 update

    I think this is a little off the subject but think from what I read that you may be able to help. I have a 1830 Case skidloader that I was told needed hydrostats where do I go to find them and can you explain to me what oil should be used as hydraulic seems to get awfully thin
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top