Recent content by tarment10

  1. T

    IH 300u problems

    Hopefully a final update here. I figured out what the issue is and I'm pretty sure I fixed it. Just wanted to post on here in case anyone else runs into the same issue. To recap, the tractor's ignition timing was changing for seemingly inexplicable reasons. I first noticed it while...
  2. T

    IH 300u problems

    Update to the update. The troubles continue. After adjusting the timing, the tractor seemed to be running really nicely. I changed the alternator because the battery wasn't charging....and now it still doesn't charge, but that's not the issue I'm coming back to the forum for. After the...
  3. T

    IH 300u problems

    An update for everyone, but first, thanks for all the commentary here. I started by looking for issues in the fuel system. I took the carb off and looked to see if it was clogged up as some suggested. No issues there. cleaned a few things up, but mostly just reassembled it and put it back on...
  4. T

    IH 300u problems

    The brush hog is attached using the three point adapter prongs, like these https://www.yesterdaystractors.com/Farmall-300_Fasthitch-to-3-Point-Quick-Attach-Prongs_111429.html , plus a top link. I'll check the distributor and hydraulic lines, but I have raised/lowered the brush hog and didn't...
  5. T

    IH 300u problems

    Hello all, I'm looking for some initial troubleshooting guidance. I recently purchased a 5 ft brush hog to attach to my also recently purchased 1955 IH 300u. When I hooked it up for the first time I took it for a test spin through some tall grass and things quickly went sideways. I noticed...
  6. T

    300u hydraulic actuator parts

    Thanks for the info here. This is really helpful for this and future repairs. Appreciate you providing this response.
  7. T

    300u hydraulic actuator parts

    OK, that sounds good. I was starting down that route and wasn't sure if there was an easier way. Thanks for the suggestion.
  8. T

    300u hydraulic actuator parts

    I recently purchased a 1955 IH 300 utility and I'm trying to find a gasket and o-ring set for the rear lift cylinder hydraulic actuator, the one that is on the right-hand side of the seat frame. My actuator has a selector switch for either single or double-action hydraulics. I have tried looking...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top