-
T
Ford 7710 PTO Gears Noisey
Thanks for the input from everybody! We got it going and used it to pull a 15' bushhog this weekend with no problems.- TCFarm2261
- Post #1
- Forum: Ford
-
T
Ford 7710 PTO Gears Noisey
The manufacturer service manual said that the output shaft should turn with 0-5ft/lb torque. The endplay specification was .001-.029in for the upper shaft and .003-.005in for output shaft. Checking the torque to turn output shaft was the very last step for installation in the service manual...- TCFarm2261
- Post #1
- Forum: Ford
-
T
Ford 7710 PTO Gears Noisey
Last week bearing went down on upper PTO shaft while rolling hay. Chewed up all the rear pto gears. Replaced the upper and lower gears. Installed the proper shims(according to manual) and checked the endplay and torque required to turn shaft, but get lots of noise from pto at idle. Smoothes out...- TCFarm2261
- Thread
- Replies: 8
- Forum: Ford
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy