-
T
385 JD Baler
Extremely appreciate the info. As I understand it from posts; I can't reduce the pressure as that's what holds the back end closed. Do you think this is correct? As I said in another post, my local JD dealer said to reduce travel speed. My understanding is this would allow the pressure to...- td182b
- Post #1
- Forum: Implement Alley
-
T
385 JD Baler
So is there any way to bale silage with a 385? I talked to my local JD dealer service manager, he suggested reducing travel speed to allow the pressure to dissipate. Any thoughts?- td182b
- Post #1
- Forum: Implement Alley
-
T
385 JD Baler
I found where you found the diagram and have been comparing this one for the 435/535 with the one on the 385. Do you think the two would interchange? I can also see by the diagrams where to plumb in a pressure gauge.- td182b
- Post #1
- Forum: Implement Alley
-
T
385 JD Baler
Very much appreciate the info. I'd sure be interested in your drive shaft if it'd fit. This one is a CAT 4, the shaft from the U joint is approximately 20 inches long, 1.25 inch dia., 20 spline. It is 540 PTO, with a constant Velocity joint in it. I'm very interested also in the Adjustable...- td182b
- Post #1
- Forum: Implement Alley
-
T
385 JD Baler
I found some very good old posts on this site that are too old to reply to, so have to start a new thread. I have a 385 JD Baler w/ the silage kit that keeps shearing the shear bolt when trying to bale silage. I read a post about putting on a pressure adjusting valve and gauges. Would anyone...- td182b
- Thread
- Replies: 21
- Forum: Implement Alley
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy