Recent content by Tebernok

  1. T

    Timing problems!

    Wanted to say thank you to all of you guys! I got my timing all set and its purring like a kitten.
  2. T

    Timing problems!

    I have a pressure gauge and a timing light.
  3. T

    Timing problems!

    Could the backfire be from having the timing 180 degrees off or would it not run in that configuration?
  4. T

    Timing problems!

    Was just messing with it and got it running albeit pretty rough. I messed with the distributor positioning and it evened out but then started to backfire. Im gonna mess around more tomorrow as its dark and my hands are frozen.
  5. T

    Timing problems!

    I have seen the timing marks. Im going to see if maybe I'm on the exhaust stroke. Im maybe too cautious about spinning the flywheel and just need to push it farther.
  6. T

    Timing problems!

    I'm struggling with getting the timing right on my 1950 8N. At the top of the compression stroke in #1 cylinder the flywheel timing marks are nowhere to be seen. My question is, could I have screwed up the flywheel position by inadvertently spinning it in the wrong direction with the...
  7. T

    1950 8N Side mount distributor question

    Can you suggest a brand?
  8. T

    1950 8N Side mount distributor question

    If the distributor cap is on i can spin it by hand with the spring clamps on.
  9. T

    1950 8N Side mount distributor question

    I was having some issues with rotors busting in my distributor, after 3 of them I noticed that the top half of my distributor seems really loose and spins freely, is that normal? If not, is there some adjustment to make or is the distributor shot? As far as I can tell it is the original...
  10. T

    1950 8N 12v positive or negative ground?

    So I checked it and its 4.7 ohms, jumped the resistor and wired the coil correctly and it fired up. Looks like a new resistor is in order. Thanks for all the help!
  11. T

    1950 8N 12v positive or negative ground?

    So after reading all these replies I think I may know the problem. I have the inline resistor that came with the conversion kit hooked up but I think I have the coil backwards. When I get home I'm going to flip it and see if that helps. Im also going to check the points, I don't think they're...
  12. T

    1950 8N 12v positive or negative ground?

    So this may seem like a dumb question, was I supposed to change the coil? It still has the 6v coil.
  13. T

    1950 8N 12v positive or negative ground?

    Its a side mount.
  14. T

    1950 8N 12v positive or negative ground?

    I recently converted my 8n from a 6v to 12v, before the conversion it ran fine (always been a little finicky to start) but now it seems to be a bear to get started and when I do get it running it seems to lack power. Will reversing the ground make a difference? This is my first foray into...
  15. T

    Any michigan boneyards?

    I'm looking for a rusty old project, something I can throw a lot of man hours at. I only seem to find stuff that needs a little work. I'm hoping to find a tractor that's been in the weeds on somebodies back 40 for 30 years. 😂
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top