(800) 853-2651
SHOP NOW

Recent content by techinny

Yesterday's Tractor Forums
  1. T

    Farmall C c-153 Spark Plugs

    I run Autolite 388 plugs in my C153 and my H, put new ones in at the beginning of every season, they work for me.
  2. T

    Bolt on hubs

    They WHAT break easily?
  3. T

    What is the perfect tire wear for antique pulling?

    If the centers are worn more, they were run with too much air in them. Our rules say no cut tires, road worn (the front of the tread taller than the rear) however are allowed, which are "naturally" cut. As far as the perfect wear for pulling, depends on the track conditions and how much power...
  4. T

    Mid Atlantic Antique Tractor Super Pull in Harrisburg, Penns

    Anyone from MI going to Harrisburg that would be interested in picking up in MI and bringing a set of 9 bolt hubs?
  5. T

    Carb and manifold size

    So one might be better off with a smaller carb......
  6. T

    1 wire alternater

    The one wire alternators don't use an excite wire so you don't need to install a diode, they are self exciting, hence only one wire.
  7. T

    Weight Rack Placement

    I made brackets that I bolted to the frame rails, the rear bolt is actually in the bell housing casting and the front bolt is in the frame rail, but the holes are spaced so that I could move the bracket further forward if needed. The weights hang parallel to the tractor so that one weight could...
  8. T

    convert to 12 volts question

    I was going to run a deep cycle battery and just charge it every so often instead of installing an alternator, but my go to guy for alternator and starter work told me to install an alternator, more voltage in the system the hotter the spark will be making more power.
  9. T

    Is H Drive Shaft Rotating? Need Ideas.

    Got it pulled apart, not any one thing sticks out and says this is the problem, the inside of the flywheel is gunked up with old grease and clutch dust, the splines on the input shaft are gunked up too. The clutch disk is not worn down to the rivets but is close. The pressure plate looks fine...
  10. T

    Is H Drive Shaft Rotating? Need Ideas.

    My H does something similar but the tractor may or may not stop moving when the clutch is depressed even when going up an incline. It does not do it all the time, and is not predictable. I made sure the pedal was adjusted, I have greased the pilot bearing and thought it had taken care of the...
  11. T

    broken bolt removal?

    Taps are hard but they can be shattered with a punch then dig the pieces out with a pick or magnet, too much experience talking!
  12. T

    H, vs SH, vs 300/340/350

    Check the Rochester or Finger Lakes CL, there's an H in Waterloo for less than $2000, don't know anything about it, I'm just one of the guys looking for a good deal too.
  13. T

    tractor pull

    Planning on going, heard it is a good pull.
  14. T

    Bypass resistor on 12 volt conversion

    I just converted to 12v also, put a 12v coil on it and ran 12v from my toggle switch to the coil. The guy that I go to for starter/alternator repair gave me a diode to put in line with the excitation wire to the alternator so it would shut off, but I do not know the specs on the diode. The...
  15. T

    Tractor hauling trailors.

    I bought a PJ 28' 102" wide 2 years ago, mind you I don't run it in the salt so it still looks new, but we have one at work and yes, once it starts there is no stopping the rust. I looked at other manufacturers and to me none compare to the PJ other than Gatormade, but the price shows it. I...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top