Recent content by The General

  1. T

    Jubilee: Runs ROUGH after 1 hour of smooth running

    Lucky for me, after replacing the ignition switch and testing it out (including shaking the harness), I reconnect the bush hog and back right over an entire village of Space Aliens... That Hog made quick work of them, and since its a John Deere, their slimy, green bodies parts were hardly...
  2. T

    Jubilee: Runs ROUGH after 1 hour of smooth running

    That's the way I look at it too. Its not going to hurt anything by removing 70 year old parts and minimizing the wire connections... -Mike
  3. T

    Jubilee: Runs ROUGH after 1 hour of smooth running

    Went out and replaced the 6V coil with a new 12V coil, and bypassed the resistor. Started and ran fine (as expected). Very soon, however, the engine did a nice 'sputter/cut-out' for just a half-second. Very different from before... Continued to operate fine for about 1 hour and then I...
  4. T

    Jubilee: Runs ROUGH after 1 hour of smooth running

    Thanks! That's a good list to work from... Personally, I'm going with Space Aliens. But I'll probably try some of the other things first... Thanks again! -Mike
  5. T

    Jubilee: Runs ROUGH after 1 hour of smooth running

    I'll bring a spark tester... Good idea I'm also wondering if my ballast resistor is breaking down... And if so, perhaps that is causing the coil to burn out prematurely. Its the original resistor. I'm thinking of shot-gunning it and removing the ballast resistor and going straight to a...
  6. T

    Jubilee: Runs ROUGH after 1 hour of smooth running

    I'll bring a spark tester... Good idea I'm also wondering if my ballast resistor is breaking down... And if so, perhaps that is causing the coil to burn out prematurely. Its the original resistor. I'm thinking of shot-gunning it and removing the ballast resistor and going straight to a...
  7. T

    Jubilee: Runs ROUGH after 1 hour of smooth running

    My Jubilee is doing funny stuff. Started this last year - Changed the Coil and I 'thought' it fixed it, but its back... Runs fine for about 1 hour. Gradually, it starts running rougher, and you can see the governor linkage surging, but not excessively. Kick up the throttle and it...
  8. T

    1953 Jubilee - Lift arms 'jump'

    Question - When I look through the websites and even catalogues (like Steiner Tractor Parts) they quote the SAME safety valve for BOTH tractors (8N/9N, 2N and the NAA, and Jubilee) The NAA original part number is NAA984F. Everyone says that the 8N638 will work too. Am I missing something...
  9. T

    1953 Jubilee - Lift arms 'jump'

    Thanks!! I did a quick search on 'Hiccup' and the forum lights up like a pinball machine! I'll do my homework and see what I discover... Thanks again for the assist. -Mike
  10. T

    1953 Jubilee - Lift arms 'jump'

    I'm sure this has been answered 1000 times before, but I'm new to the forum, so please forgive me. My 1953 Ford Golden Jubilee Lift Arms will 'bounce'. What I mean by that is: They will lift and lower fine, but while trying to hold a heavy object (like the bush hog), they will sag some, then...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top