Recent content by theking5983

  1. T

    Hydraulic relief valve

    Where can I get washers to shim the relief valve?
  2. T

    Hydraulic relief valve

    what's the best way to test to see if my hydraulic relief valve is set correctly? I change the pinion and added the bigger hydraulic pump for 1650-1850 and I have not changed my relief valve settings
  3. T

    Front tires 1550 gas

    And we are the second owner of this tractor it was purchased new from are local Oliver dealership in 1967 by a local dairy farmer I worked for said he then purchased a 1650 diesel in 1969 because it was better on fuel then the gas he said he used it for lite duty after he got the 1650 when I...
  4. T

    Front tires 1550 gas

    Added at photo of the hub
  5. T

    Front tires 1550 gas

    If I wanted to put a wider tire and rim on my 1550 would I have to switch my hubs I notice most of the wider tire and rims setups I have seen have a smaller bolt pattern on the hub? now that i got the steering straightened out fixed the pitman arm also the manual steering box is it filled with...
  6. T

    Hydraulic pump whining

    I did two new gaskets and no I have a 1550 I used the pinion gear from a 1650 so I could use a 1650-1950 hydraulic pump because finding a 1550 9 tooth pump was one hard to find and the few I found were expensive and the newer style pump has a few more gallon per min flow from what I was told...
  7. T

    Hydraulic pump whining

    can hear the pump at all times idle or when I am using the loader I am not sure if it is a whining now or if it is just the noise the pump makes I replace the pump with the pump for the 1650 so I changed the gear that drives the pump to fit the new pump I replaced the bearings and races, used...
  8. T

    Parts searching steering cylinder kit & steering Bus

    will try that I noticed the pitman arm has a little bit of play to it as well it there a bushing in them in the parts manual it looks like there is a bushing, also if anyone has any idea on a replacement power steering pump that would fit the setup on there this one is weak and noisy
  9. T

    Parts searching steering cylinder kit & steering Bus

    t is pretty loose the u joints in the linkage have some play and like I said above 15mph the wheels start to turn back and forth by themselves,
  10. T

    Parts searching steering cylinder kit & steering Bus

    added photos one line u can see run to hydraulics and the other to the hydraulic cooler part manual just states pump
  11. T

    Parts searching steering cylinder kit & steering Bus

    thank u, and my 1550 has a pump that runs of the Hydra drive it sits right next to the distributor I cannot find any info about it? question 2 is my steering cylinder has not lines that run to it and there is no line on the tractor for it I see in all the rebuild videos they have hydraulic lines...
  12. T

    Parts searching steering cylinder kit & steering Bus

    looking for a steering cylinder rebuild kit or individual parts to repair it, and i am looking for the round bumper bushings that go on the front axle I think they are part number K 504 but not 100% sure and a I think it called the rear steering bushing paret # D-719 all for my Oliver 1550 the...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top