(800) 853-2651
SHOP NOW

Recent content by Thompson Mike

Yesterday's Tractor Forums
  1. D

    450 rocker assembly what is missing pics???

    front of head has tube tapped in head, rear of head is tapped (threaded) for i am not sure what. I removed head for crack repair and don't recall what I may be missing. Thanks for your input.
  2. H

    Massey Ferguson

    looking foor a serial number chart for Massey Ferguson 25 ( perkins diesel ) tractor
  3. M

    Massey 1040

    Anyone know where I can get clutch and rear brake parts for Massey 1040. Do any of the parts cross over to another manufacture?
  4. jon f mn

    Today's funny

    .
  5. O

    TO 35 oil pump

    The plunger was stuck in the oil pump. I screwed a 3/8 pipe tap into it and heated the housing with a torch. I clamped a vice grip onto the tap and worked it back and forth, then I tapped the vice grip with a hammer and the plunger came out. After rebuilding the pump I put the cover plate on and...
  6. J

    4430 Brakes

    On this newly acquired 4430, the right brake pedal is sticking. I can push it in but have to pull it back to release. Left brake works fine. Suggestions? TIA!
  7. C

    414,436,466 head value

    What is this worth? Bare head. Had checked and has no cracks. Number is. 680426c1.. is this the head number tractor pulled like getting a hold of? Just curious.
  8. B

    filler neck repair on super m

    What is the best way to repair a broken filler neck on super m, radiator, also how to remove radiator
  9. T

    Gas 3000 stalling after running for 1/2 hr.

    I am dealing with a carb issue on a 3000 also FYI a new factory gas cap is 65.00 this one was bad. It does need to be a vented cap and I could not find one anywhere else. good luck
  10. T

    Ford 3000 carb problems on hill

    when i had it off it never seemed to have fuel in it and it did not look bad in anyway
  11. T

    Ford 3000 carb problems on hill

    has new fuel pump on front of engine, half tank of fuel. same both ways. I read on an old post something about this tractor having a hillside kit available for the carb but the guys did not know what that would consist of. I will have to check with dealer if it is still around or if it...
  12. T

    Ford 3000 carb problems on hill

    I'm helping a neighbor on a 1974 3000 gas. I got it to run great, starts great but when he is mowing the ditch and gets it on an angle it will sputter out and die. Pull it to level it will sputter some but then clean out and run great again. I have tried float at a couple different settings...
  13. M

    c301 in a 460

    hello I would appreciate any tips or advice in transplanting a c301 in a 460 ... I have tractor and motor and this will be a winter project in the shop... what Im wondering is what motor plates to use on the front and rear Im assuming I will need to bolt the 460 motors plate to the 301 on the...
  14. T

    1600 timing???

    Working on a 1600 gas, it had a full tune up and carb rebuild was running through the summer great. Fired it up brought it out of shed then it all of a sudden started to load up, slobber and die. Will not start now. it has fire and I put a good running carb off another tractor on and still...
  15. T

    1255 Hi-Crop oil psi

    I recently bought a 1255 hi-crop out of California that a friend had owned for many years. When I got it here I serviced all the fluids and filters. Now if I let it sit for more than a couple days without starting it it loses prime on the engine oil and I show no psi. If i pull the filter and...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top