-
T
Questions on well pump
Well, the digger just left - of all the responses, you got closest - the pump shaft is broken and the tank is bad. The only good news was that the motor was ok. I guess 10 psi was the indicator on the tank since apparently it should have been around at least 38 psi. The digger reckoned that...- Tinkerer05
- Post #1
- Forum: Tractor & Farm Talk
-
T
Questions on well pump
Well, the digger just left - of all the responses, you got closest - the pump shaft is broken and the tank is bad. The only good news was that the motor was ok. I guess 10 psi was the indicator on the tank since apparently it should have been around at least 38 psi. The digger reckoned that...- Tinkerer05
- Post #1
- Forum: Tractor & Farm Talk
-
T
Questions on well pump
I have a two wire well pump at approx. 385ft. There is a Pressure Tank and a Pressure Switch (40/60). With power off, I measure: • 4.8 ohms between the two wires going to the pump (manufacturer’s winding resistance spec says 3.2 – 3.8 ohms, plus cable resistance from the well head to the pump...- Tinkerer05
- Thread
- Replies: 13
- Forum: Tractor & Farm Talk
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy