Recent content by Tinyhumangiant

  1. T

    Parasitic Drain on Ford 8N with brand new 12V conversion

    I'm not opposed to changing the way I wired it, I just like to understand the "why" for what I'm doing (It helps my brain remember, so I can diagnose, repair, and not make the same mistake in the future)
  2. T

    Parasitic Drain on Ford 8N with brand new 12V conversion

    So after some inspection (and after ordering and paying for a set of RFI resistant wires, it turns out that the previous owner had installed Motorcraft Sipcon spark plug wires (which it seems are RFI shielded and do not have a copper core). So I have been running those for now at least. (Not...
  3. T

    Parasitic Drain on Ford 8N with brand new 12V conversion

    Update. Thank you to all of you who have commented and helped me out, I learned several things that were only tangentially related to my initial question, but were things that I had overlooked. As several of you suggested, yes the battery turned out to be the problem. I made the mistake of...
  4. T

    Parasitic Drain on Ford 8N with brand new 12V conversion

    I have a digital multimeter (which I am still learning to use) but I tried to check for an amp draw between the negative battery pole and the negative wire, and (assuming i did it correctly) I didn't read anything. however, I also checked battery voltage, and noticed that it seemed lower than it...
  5. T

    Parasitic Drain on Ford 8N with brand new 12V conversion

    Thanks! I double checked the Pertronix install guide, and you are correct. I'll be looking for a replacement set with "RFID suppression" tomorrow. I assume plug wires made for modern vehicles would all be set up this way?
  6. T

    Parasitic Drain on Ford 8N with brand new 12V conversion

    Yes, while charging (engine running) it usually reads around 14v, when I shut the engine off and then turn jus the key on to check battery voltage, it usually reads 12 to 13 (at least immediately after charging). The problem is that this number seems to drop after it sits for a few hours.
  7. T

    Parasitic Drain on Ford 8N with brand new 12V conversion

    So (checking comprehension here) by including a lamp, diode, or resistor I can make sure that I don't toast my switch or melt my wires by inadvertently trying to charge the system through the exciter wire while the engine is running (in the event that my charging wire has a bad connection, and...
  8. T

    Parasitic Drain on Ford 8N with brand new 12V conversion

    I'm not saying I did everything right. I'm saying I thought I did, but something isn't working so I obviously did not do everything right, and don't know where I went wrong. Sorry to bother you with my lack of understanding. Would you mind explaining why using the third terminal on the switch to...
  9. T

    Parasitic Drain on Ford 8N with brand new 12V conversion

    My understanding is that the diode is essentially a check valve, and is just there to interrupt the flow of electricity coming back down the exciter wire (from) the alternator to the rest of the electrical system to prevent back feeding (which would prevent you from turning the engine off by...
  10. T

    Parasitic Drain on Ford 8N with brand new 12V conversion

    I put the battery on a charger this afternoon, I took it off and unhooked the negative cable this evening. I'll check in the morning if the battery is still charged or not. I've got a digital multimeter, so assuming the battery checks out at a bit over 12v in the morning, I'll try checking for...
  11. T

    Parasitic Drain on Ford 8N with brand new 12V conversion

    Yes, I can turn the key to on to check the battery voltage without cranking the engine over though.
  12. T

    Parasitic Drain on Ford 8N with brand new 12V conversion

    Voltmeter is wired to shut off with the key, it's reading over 12 volts while the engine is running, but I can shut the engine off with the key and then turn the key back to the on position to briefly check battery voltage on the voltmeter without cranking the engine over (that requires pushing...
  13. T

    Parasitic Drain on Ford 8N with brand new 12V conversion

    I recently converted a Ford 8N tractor with a side-mounted distributor from 6 volt positive ground to 12 volt negative ground I upgraded the coil to 12v with an internal resistor, got rid of all the original resistors, added a pertronix electronic ignition kit, swapped out my headlight bulbs...
  14. T

    New Old Stock Tractor Build/Possibilities

    Do you have links to any pictures of these or anything? This is fascinating. Would I be correct on assuming these are knock-offs in the sense that MF doesnt license their branding?
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top