TJ64's latest activity

  • T
    TJ64 replied to the thread Front wheels.
    That is what I did to the other side. took an angle grinder and then wire wheel to it. Rust primer,and a rubber strip around the middle...
  • T
    TJ64 reacted to Lynn Patrick's post in the thread Front wheels with Like Like.
    I try to get them VERY clean & smooth, but then, I'm old & retired & spend almost all my days in the shop doing things like that! For...
  • T
    TJ64 replied to the thread Front wheels.
    yes, dishsoap, a maul, working it on with a tire spoon. On and off 3 or 4 times now.
  • T
    Hi 8nTroubleMan, Welcome!! If it says 8N-B in the raised casting behind the starter, the engine a sidemount 50-51. 8N -C came out at the...
  • T
    TJ64 replied to the thread wide front tires.
    Where are you finding 6.00-16's for $130 a pair? Best prices I'm finding are $109 each for tri ribs.
  • T
    TJ64 replied to the thread Front wheels.
    My tire guy gave me a new set of tires.(NOS , some checking from sitting outside) One side will NOT come up on bead in a small section...
    • IMG20260710113724.jpg
    • IMG20260710114415.jpg
  • T
    TJ64 reacted to Duner Wi's post in the thread Front wheels with Like Like.
    Your plan should work fine. If you want to save $50. bucks I have used temporary spares on the front . Lot of times you can get them for...
  • T
    TJ64 posted the thread Front wheels in Ford 9N, 2N & 8N.
    I'm trying to get by for a few more months on these old nasty tires on the front. I had a flat, aired it up and hauled a couple logs...
  • T
    Every part I have ever needed these good folks have provided...
  • T
    TJ64 replied to the thread Primary seal etc......
    I buy some here. I don't do so blindly though, I don't remember what it was that I was looking at a while back but there was a $45.00...
  • T
    TJ64 reacted to soaked's post in the thread Primary seal etc..... with Like Like.
    I Buy parts here.
  • T
    TJ64 replied to the thread Primary seal etc......
    Yeah! That is the one they sent me from Steiner. A straight thru bolt design like your pic is pretty straight forward. That is what it...
  • T
    TJ64 reacted to soaked's post in the thread Primary seal etc..... with Like Like.
    Haven't seen one like that. Is for a sidemount 8n?
  • T
    TJ64 replied to the thread Primary seal etc......
    Both ends are a stud.... different type.
  • T
    TJ64 replied to the thread Primary seal etc......
    • 1000002499.jpg
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top