(800) 853-2651
SHOP NOW

Recent content by TO-30GUY

Yesterday's Tractor Forums
  1. T

    Ford 5000 turned into oil painting

    1971 Ford 5000
  2. T

    ‘71 Ford 5000 power steering box loose

    Holes for the pins were egged out. Drilled and tapped to 1/2” thread, put 1/2 to 3/8 inserts in. Cut heads off 3/8 bolts (upper holes are 3/8) and loctite and threaded in. Back together and working good now. Thanks all.
  3. T

    Moisture in the power steering system?

    Most likely moisture build up over time, drain and refill. I use atf in mine, can use hyd oil as well
  4. T

    Ford 4000 diesel cranking slowly

    Buy the biggest gauge you can afford, I prefer 1/0 or 2/0
  5. T

    ‘71 Ford 5000 power steering box loose

    Are they replaceable? Pound out or press out? Any idea if I could tap the hole and thread in studs? Thanks
  6. T

    ‘71 Ford 5000 power steering box loose

    Wondering if anyone knows if these two holes should have pins or studs in them coming up from the trans housing? My power steering box keeps loosening and sliding back and forth when I turn. Looks like it’s just in the four mounting bolts, wondering if there’s supposed to be 2 pins and mine are...
  7. T

    Running a hydraulic sprayer pump behind a 71 Ford 5000

    Ok, going to try it out with water at some point after I modify the booms, modifying them for pumpkins, going to hang 30-40’ just off to one side, at 20” spacing that’s 18-24 tips, current tips are .2 gpm at 60psi so that only comes out to 6 gpm at the max I would think I should be able to...
  8. T

    Running a hydraulic sprayer pump behind a 71 Ford 5000

    Bought a sprayer with a hydraulic pump, no hydraulic booms or anything just the pump. Want to run it behind my 1971 ford 5000. Will I have enough hyd flow? Specs for pump say 7 gpm at 115 gpm pump flow, I don’t need that much flow on the sprayer. Tractor data says the 5000 has 6 gpm. Also see...
  9. T

    Question about oil and hydraulic change

    Central Wisconsin. I run 10-30w and have good oil pressure. GL-1 in the trans, little slow in the winter until it warms up but isn't bad.
  10. T

    TO 30 Headlight wiring routing

    I am electrician by trade so the schematic isn't an issue I was just wondering how everyone ran the wire so you could still open the hood. Thanks Jim
  11. T

    TO 30 Headlight wiring routing

    Installing new headlights and rear work light and wondering where everyone runs the wires from the dash area to the lights with the hood opening and all unlike the fords. Thanks
  12. T

    Throttle linkage

    #17 thanks
  13. T

    Throttle linkage

    yes that ball joint that comes off the left side of the u bolt
  14. T

    Throttle linkage

    Is that the one that is right next to the water pump directly above the governor? I'm having a hard one telling which one is the right one and which is the one that is farther back near the driver and the actual throttle lever. Thanks
  15. T

    Throttle linkage

    Can't find the part number for the ball joint linkage part that bolts to the U-bolt and goes to the governor, any help appreciated thanks.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top