(800) 853-2651
SHOP NOW

Recent content by Todd C.

Yesterday's Tractor Forums
  1. T

    8N and TEA Ferguson

    Are the input shafts the same for an 8N and a TEA Ferguson?
  2. T

    801 hydraulic line problem

    So I brazed the split in the big line and used the soapy water to confirm that there were no leaks. Then I blew air into the smaller pressure line and air was coming out of the transmission housing. I thought that can't be good. I split the tractor at the differential/tranny and noticed that...
  3. T

    801 hydraulic line problem

    Discovered that the larger (return?) hydraulic line in the clutch housing is split presumably from water freezing in the line. Can you find this line? Can you get them out? Can you put a smaller line inside this one? Can it be brazed in place? The split is about at 4:00 o'clock - about a foot in...
  4. T

    971 front end seals

    Please post the number of the seal if you find one. Thanks. Todd in Kansas.
  5. T

    801 headlight bulbs - 6V vs 12V

    I have several unattached headlight from 801 era tractors and some of the bulbs are not stamped 6V or 12V. Is there a way to tell what the are without burning out the bulb? - ie hooking up a 6V bulb to a 12 V system.
  6. T

    9N Hydraulic lift piston rings

    Cylinder is smooth with no scratches.
  7. T

    9N Hydraulic lift piston rings

    I stand corrected. It's amazing these are still going after 70+ years.
  8. T

    9N Hydraulic lift piston rings

    With this piece of junk 9N the cylinder would be more than the tractor is worth. Fixing for a neighbor......
  9. T

    9N Hydraulic lift piston rings

    Maybe a five foot blade or mower.
  10. T

    9N Hydraulic lift piston rings

    I don't think I'm going to lift 1500 big bales with it!
  11. T

    9N Hydraulic lift piston rings

    What is the thickness of new 9N hydraulic cylinder piston rings? I miked the old ones at between .112 and .123 depending on the ring and position on the ring. I'm getting some leak down. New rings or just get a new piston with backup washer and o-ring?
  12. T

    dearborn ledger plates

    This message is a reply to an archived post by Darryl 2 Ms on August 01, 2012 at 20:14:07. The original subject was "Re: dearborn ledger plates". I have 64 of these ledger guard plates. 142570. Let me know.
  13. T

    Ford 9N 9-32 inch rims

    I think I will take the tires off and see.
  14. T

    Ford 9N 9-32 inch rims

    They are not rusty as far as I know. The tires are still on them so I suppose they could be rusty but they sure don"t appear to be. Located in Kansas.
  15. T

    Ford 9N 9-32 inch rims

    What are 9N Ford 9-32 hat rims worth? Near mint considering the age.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top