(800) 853-2651
SHOP NOW

Recent content by Todd Dykman

Yesterday's Tractor Forums
  1. T

    M - Finally restored

    nice job. she's a beauty.
  2. T

    D John Deere tapped exhaust?

    That is really interesting. Please let us know what you find out. I've never seen that before.
  3. T

    Port Orchard Washington

    Is there a show/pull on the weekend of September 13 and 14? there usually is but I haven't seen anything about it
  4. T

    Frankenstein Hay Wagon

    I was given a hay wagon that is a true farm classic. Back half is McCormick Deering and the front half is IHC. I'm going to paint this thing... I think I'll just go with JD Green to match the tractor. Any better ideas?
  5. T

    Hay Wagon

    I was given an old ratty hay wagon, that was used by an old farmer across the street from the family farm my dad grew up on. Needless to say it's in poor repair, needing all new deck. Interesting thing. It's IHC in the front and McCormick Deering in the back. So, I'm painting it John Deere...
  6. T

    Smoke out of oil fill cap? [Model M]

    I agree change the oil, run it, let it warm up and if it happens again. You're going to have the opportunity to really get to know the inside of your tractor well. I had a similar problem when I brought mine home, I was hoping for just a head gasket. I had a much larger problem. But, it's...
  7. T

    Model D compression ratio

    Hey Bob, That would be great. I almost made it down to show down there by Toledo this last weekend. There is one up here is Port Orchard in September I'm planning on heading to. Here's a pic of the D. And How do I get a hold of you? Todd
  8. T

    Model D compression ratio

    Anyone know the compression ration for a Model D. Mine is a '35 model D unstyled, block bored .090 over.
  9. T

    Skid plate / wheelie bars

    does anyone have pictures of a possible set up for a jd model D
  10. T

    Skid plate / wheelie bars

    I just finished restoring a 1935 john deere model D (unstyled). I would like to pull it just for grins, but I need to get some skid plates on it. I want to keep the tractor as stock as possible, bolt on? I'm thinking I can just bolt something on along with the drawbar. Any ideas, guidance...
  11. T

    sweaty carborator

    Was running my 1935 model D for a short while yesterday. just finished the overhaul/rebuild/restoration. Anyway. I noticed that the carborator was sweating... it was a little humid out, but not bad. is that something normal? should I be concerned?
  12. T

    Welch plug under clutch fork shaft bearing

    thanks all. got it handled
  13. T

    new head gasket

    I use a fine spray of permatex hi-tac . the red stuff
  14. T

    Welch plug under clutch fork shaft bearing

    oops it"s a 1935 john deere model D
  15. T

    Welch plug under clutch fork shaft bearing

    Is this part still avail from Deere (30H or 11R) The plug that is there is cockeyed and drips a little, need to make that stop. I'm not sure where to find the part or how to remove or install the new one. Any ideas?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top