Recent content by Tom in OR

  1. T

    8N Proofmeter cable

    Recently purchased a new 8N Proofmeter cable. I find a very small brass washer included with the new cable. Thrust washer? Which end of the cable does the brass washer go into?
  2. T

    Quality Voltage Regulator

    Try Brillman? www.brillman.com
  3. T

    Farmall M or H Transmission Have Yellow Metal

    And, yes, there are bronze bushings for the reverse idler gear, but none others that I am aware of.
  4. T

    "M" quit

    That's also how they act when a coil goes bad. Would it start and run again after cooling for a half hour?
  5. T

    lights

    Thank you, Jim.ME! Really appreciate your reply. Will give Dennis Carpenter a try.
  6. T

    lights

    Is there a source for those retainer clips as used with a sealed beam bulb that are shown in Tim Daley's photo? Tried making my own out of piano wire with little success. Thanks, Tom
  7. T

    Corn head grease

    I've had cornhead grease in the steering box of a Ford 8N for the past 10 or 15 years. Works great in the prone to leak Ford steering gearboxes! Drilled and tapped the casting and installed a grease fitting. No mess, easy to top off any time.
  8. T

    Ohms rating of Ballast Resister

    Thank you, John T and Texasmark! It makes sense as you guys explain it! I will pursue this!
  9. T

    Ohms rating of Ballast Resister

    On a 1950 M with a 12 volt generator and 12 volt system, positive ground, still using the original IH 6 volt coil, what should be the recommended value for the ballast resister? I have searched far and wide and found the ohm ratings of advertised ones vary all over the map, from 0.6 to 3.0...
  10. T

    Got radiator tanks cleaned down to shiny brass

    Thank you, guys! I got into this because the radiator had failed joints at the bottom tank/side rail connection on both sides. Got them repaired very well by a radiator shop. While the radiator is out, I couldn't resist removing layers of gobbed-on paint coatings, including some areas of...
  11. T

    Got radiator tanks cleaned down to shiny brass

    Now what is the recommended treatment for preparing the brass (and solder) for painting? Tractor is '50 M. Thanks for any advice! Tom
  12. T

    M Radiator Removal

    Thank you, fastfarmall, that is just about exactly what it looked like to me! Appreciate your response! Tom
  13. T

    M Radiator Removal

    Does anyone have any advise on removing a 1950 M radiator? The joints at the bottom end of the side rails where they are soldered to the bottom tank have failed. Actually, it looks like the original soldering job was not that great. It appears that if the fan shroud is loosened and moved back...
  14. T

    NAPA oil filter no. For a Farmall M

    Just be aware that NAPA no longer supplies a new O-ring seal with their filters! Available at extra cost if I remember correctly.
  15. T

    Replaced '50 M brake bands

    Thanks for all of your replys! I will let you know how it turns out!
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top