(800) 853-2651
SHOP NOW

Recent content by Tom Massachusetts

Yesterday's Tractor Forums
  1. T

    Old Carriage Bolts

    Elevator bolts have a larger square with a larger flat head. I have used them to replace old carriage bolts.
  2. T

    Average age of user

  3. T

    MH 50 steering

    I have a MH 50 with manual steering. It is a great tractor but steers hard for my wife. Is there a kit to change it over to a power steer?
  4. T

    Kioti DK40 fuel gone/

    Replaced the mechanical fuel pump, changed the oil and filter, been fine since.
  5. T

    New fuel pump problem DK40

    Bought a new pump and went to install. The new pump has a part that sticks into the engine is not machined, it is just a casting and is too fat to fit in the hole on the engine. The original pump was machined in this area. The casting is about .020 too big to fit. I looked other replacement...
  6. T

    Kioti DK40 fuel gone/

    wENT TO START MY dk40 this spring and the tank was empty. poured in 5 gal diesel then 15min later tried to start, almost started then stalled. checked the fuel and it was empty again. Checked the oil level and found the fuel. I guess the pump is bad. Has this been a problem?
  7. T

    Shouler pain

    torn rotator cuff, could not lift my arm. surgery and therapy, 6 mo later full range and no pain. 5 years later still good.
  8. T

    Drum retaining screws

    eat the head of the screws red hot with a torch, let them cool, take them out with a screw driver. Done many of them, never failed.
  9. T

    2023.05.31 Rust Pic

    also have a MH50 and mine is very hard steering. Is there a fix for the steering?
  10. T

    NAA w/o lift?

    f it has no lift, then I would think it would not have a pump, no need. That would make it much cheaper.
  11. T

    Tuesday Truck Pic

    hat picture is not an "T" conversion. The base i s a"A" with a 3 speed trans and a clutch. can see the dash "A" style and the shifter sticking up, unlike an "T" that shifts with the the pedal. It would freewheel in neutral.
  12. T

    Engine seal question for 52 8N

    work on a lot of old vehicles and have replaced this type of seal by loosening the main bearings a couple of turns to give more room to pull the seal thru. I also have just replaced the lower half of the seal on occasion. Good luck, not a fun job.
  13. T

    1951 8N hard first start

    ust put the 51 carb on the 48 and had the same problem. The problem seems to follow the carb.
  14. T

    1951 8N hard first start

    Thats a good question. I should try that .
  15. T

    1951 8N hard first start

    It cranks fast with the 12v and starts good with the other carb.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top