Recent content by tonastoy

  1. T

    706 trans

    i tried the magnet trick first with no luck, took the inspection plate off the back of the rear end and was able to see to the front, used about a 5 ft piece of 5/8 round stock and was able to move it far enough back in to get ahold of it from the tranny side again , thanks for the help guys
  2. T

    706 trans

    i lost forward gears in my 706, thinking it was in the linkage i pulled the cover off the trany to rebuild the parts and found that the shaft that the fork that shifts from low range to high rides on had come out and slid back into the rear end and the fork fell off, when i was fishing the fork...
  3. T

    Extra long h axels

    Next question, I haven't done anything with the tractor yet, it's still all original, like I said my plan was to rob the wide front for my sh and put the narrow front on this and resell it, this one still runs and the tires are good , is it worth more all together or can I rob the wide front?
  4. T

    Extra long h axels

    I bought a h for the wide front but after looking at it when I got it home the rear axels are longer than normal. Never seen this or heard anything like this , anyone have any ideas or info?
  5. T

    504 backfireing

    ok , thanks
  6. T

    504 backfireing

    what are my options on fixing this?
  7. T

    504 backfireing

    tried to run the 504 today, started up but its backfiring steady, it ran fine when I put it away , tried to adjust the timing but no change, if I pull the #1 plug wire it quit backfireing, if i hold the wire at the dist and make it arc the backfiring quits but if i start putting it under load it...
  8. T

    radiator

    Ok, I'll look tonight when I get home, thanks
  9. T

    radiator

    The radiator I bought was the one for the 806, it just fit into the casting for the width but the bolt holes don"t line up for the mounting clips, off by a couple inches. And when I have the radiator sitting on the bottom the top of the radiator would be as high as the hood tin with the...
  10. T

    radiator

    looking for info about a radiator for a 806, I bought a 806 with out a radiator and im having a hard time finding the right one, everything ive found says theres only one radiator for both the gas and diesel , ordered one and it doesn't fit, did some more research, the motor is a 263 which is a...
  11. T

    H live hyd

    There is a local guy selling a h . It has a live hyd pump off the distributor . He said something in the pump broke and now the motor won't turn over. Anyone else have this happen or have any ideas what broke and what it would cost to fix it? Thanks
  12. T

    Super h carb mystery

    i had the same trouble with my super h once too. it would run for awhile and then stall out , if i had the chock out it would run for awhile again and then start to flood. gas would run out of the carb when it wasnt running sometimes also. i had just rebuilt the tractor from the ground up and...
  13. T

    h axle shafts

    I bought a 1948 h the other day and a guy came by today and was looking at it and said i had longer axle shafts than normal and wanted to buy them. there is 24 inches sticking out past the seal. I measured all my other tractors and they only have 18 inches. was this a special order thing? I've...
  14. T

    Roto baler

    Do they make a good bale or should I suggest they look for a square baler, it's only for their own hay on a small acreage for a few animals
  15. T

    Roto baler

    I friend of mine is looking at a allis roto baler and is wondering if they use twine or can be outfitted to set one up for twine. I know nothing about them but said I"d look for info. Can anyone give me any input? Thanks
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top